Acoustical Manufacturing Co. Quad 34 Buku Instruksi - Halaman 4

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Peralatan Perekaman Acoustical Manufacturing Co. Quad 34. Acoustical Manufacturing Co. Quad 34 11 halaman.

Halaman Cetak

ACCESSORIES SUPPLIED

INSTALLATION

AC supply lead 2m long

AC Euro type output connector

2x100 mV record flags

2x100 mV replay flags

Type No. QUKES2B

Type No. PPR0413

Type No. Q34100R

Type No. Q34100P

The 34 control unit is designed to operate on one range of AC powersupply only,

50/60 Hz. either 200-240V or 1001120V . The correct operating voltage is ctearty

marked on the back. lt may be changed from 220V to 1 10V operation or vice

versa by a suitably qualified technician.

Before connecting to the AC power supply check that the voltage

range marked on the back corresponds with that of the supply.

The 34 control unit is supplied with an AC power lead with a 13A 3 pin plug with

1 3Afuse. Do not cut off this plug or use it with its fuse cover removed. lf however

for any reason the plug has to be removed then it must be disposed of and under

no circumstances plugged into a 13A socket outlet. A suitable plug can be

fitted, as explained below:-

WARNING: THIS APPARATUS MUST BE EARTHED

IMPORTANT - Fitting a mains ptug.

The wires in the mains lead are coloured:

Brown = Live

Blue = Neutral GreenMellow = Earth

The Brownwire must be connected to the terminal marked L or coloured Red.

The Blue wire must be connected to the terminal marked N or coloured Black.

The GreenNellow wire must be connected to the terminal marked E or

coloured Green or Greenl/ellow.

When a fused 13A plug is used a 13A fuse (ASTA approved to 8S1362) will be

adequate for a typical Quad system. For other types of plug, then fit a 13A fuse

either in the plug, or adaptor, or at the distribution board. lf in doubt consult a

qualified electrician.

The control unit is fitted with a switched Ac power out socket for feeding other

units in the system. Quad power amplifiers and tuners are provided with the

appropriate interconnecting cables and the diagram overleaf shows how the

units should be linked together.

lf required a spare AC output connector is provided which should be wired as

shown in the diagram below.

LIVE = BROWN

AC Power Output Connector Type CEE22. Part No ppR0413

Checking the AG

Power Supply

Connecting to the

AG Power Supply

Note

AG power Output

page 3