Acoustical Manufacturing Co. Quad 34 Buku Instruksi - Halaman 5
Jelajahi secara online atau unduh pdf Buku Instruksi untuk Peralatan Perekaman Acoustical Manufacturing Co. Quad 34. Acoustical Manufacturing Co. Quad 34 11 halaman.
Halaman CetakPositioning the
Gontrol Unit
Gonnection to
the Amplifier
The 34 can be positioned free-standing, panel mounted or stacked with other
components. Never place it in persistent direct sunlight or near any heat source.
Do not stand directly on top of a high power amplifier, such as the Quad 606,
as such amplifiers can generate a substantial amount of heat.
For panel mounting the panel should have an aperture of 312x56 mm through
which the 34 is fixed. Remove the 34 cover (two screws through the back ), slide
the unit through the aperture from the front and replace the cover from behind
thepanel. Refitscrewsinitiallyfingertightthengiveonefurtherhalfturntol
the unit firmly in position (longer screws can be supplied on request, if the
thickness of panel makes this necessary).
6617 CD PLAYER
AC power and signal connections for a typical QUAD system
The output of the 34 control unit is 500 mV suitable for all Quad transistor
amplifiers but this can be changed to suit different amplifiers (up to 1.6V max -
see changing output level chart opposite forfull details). Phono sockets are
fitted and the cable supplied with the power amplifi er should be used. Make sure
that the plugs are pushed fully in, at both ends, to ensure good connections.
Poor connection will cause hum.
page 4