ClearWater Lights CANopener Manual - Halaman 8

Jelajahi secara online atau unduh pdf Manual untuk Aksesori Sepeda Motor ClearWater Lights CANopener. ClearWater Lights CANopener 13 halaman.

Clearwater CANopener operation and features

HIGH BEAM MODE

The Krista/Erica/Sevina lights can be programmed for three modes of

operation in conjunction with high beams. Toggle these modes by pressing

and releasing the (TSC) button, holding the front brake lever then pressing and

releasing the FTP button (See Fig. A below) (5) times:

•

Mode 1 – All Clearwater lights turn on 100% when high beam or flash-to-

pass is pressed. Krista/Erica/Sevina lights will not turn on with high beam

or flash-to-pass if Krista/Erica/Sevina lights are switched off.

•

Mode 2 – HIGH BEAM ACTIVATION. All Clearwater lights turn on 100%

when high beam or flash-to-pass is pressed. Krista/Erica/Sevina lights will

turn on when High beam or flash-to-pass is pressed, even when Krista/

Erica/Sevina lights are switched off (default on Version 1.6 or greater).

•

Mode 3 - HIGH BEAM FLASH MODE: Same as Mode 2, but lights will flash

for 2 seconds when the flash-to-pass button is triggered 3 times. (Version

1.91 or later).

The Clearwater lights can be programmed to strobe when the hazard

flasher button is toggled on. Toggle these modes by pressing and releasing the

(TSC) button, holding down the hazard flasher button, then press and release the

brake lever (5) times:

•

Mode 1 – OFF, no flash with emergency flasher button (default)

•

Mode 2 – strobe with emergency flasher when button is held down

(Version 1.90 or earlier), or toggled on (Version 1.91 and later). If two sets of

Clearwater lights are installed, they will alternate flashing.

WARNING:

The use of strobe mode may not be legal on public highways. Check

your local regulations. This mode is intended for parades and escorts under

certain conditions.

Page 8

FTP button

Fig. A

Page 7