Altronics Micron T 2445 Petunjuk Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian untuk Alat Listrik Altronics Micron T 2445. Altronics Micron T 2445 3 halaman.

30W Micron Soldering Iron

COMMON CAUSES OF TIP UNWETTING (solder not taking):

• The tip working surfaces are not well tinned while the iron is idling.

• Lack of flux in soldering, wicking, repairing, and touch-up operation etc.

• Wiping tip on a high Sulphur content sponge, dirty or dry sponge, and/or rag.

• Contact with organic materials such as plastic resins, silicone grease and other chemicals. 6. Impuri-

ties in solder and low tin content.

Remember to tin all new tips before use. For tip first time use, the tip should be tinned immediately after

switching on and warm up of the tip.

• Always keep tips tinned before returning to the holder, switching off or storing for any period of

time. Wipe only before using.

• Don't keep iron set at a high temperature for long periods of time as this will break down the surfac-

es of the tip.

• Don't put any excessive pressure on a tip or rub a tip on a joint. It does not improve the heat transfer

but only damages the tip.

• Never clean the tip with abrasive materials or a file.

• Don't use a flux containing chloride or acid. Use only rosin or activated resin fluxes.

• If any oxide does form, it can be cleaned by lightly rubbing with a 600-800 grit emery cloth, or

cleaning with isopropyl alcohol or equivalent. After cleaning, wet the tip and wrap rosin-core solder

completely around the newly exposed surfaces.

Distributed by Altronic Distributors Pty. Ltd.

Phone: 1300 780 999 Fax: 1300 790 999

altronics.com.au

T 2445