Altronics S 9414A Panduan Petunjuk Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem interkom Altronics S 9414A. Altronics S 9414A 8 halaman. Video door intercom

Halaman Cetak

Fig 1. Base Station.

1. Handset

2. Speaker

3. Screen

4. Power LED

5. Monitor button

6. Call button

7. Unlock button

8. Volume level control

9. Power ON/OFF switch

10. Brightness adjustment

Installation With Two Outdoor Cameras

This requires the use of the expansion junction box included with the S 9415A additional outdoor camera

unit. The junction box allows for a maximum of two indoor base stations and two outdoor camera units.

See figure 5 for a wiring diagram of this system.

Operation

When installation is complete switch the power switch to the ON position. Adjust the volume level and

brightness as desired.

When a visitor presses the call button on the camera unit the monitor speaker sounds a chime tone. The

visitors image will appear on the screen. You may choose not to respond by not lifting the handset, the

visitors image will disappear within 20 seconds. To respond to a visitor you can pick up the handset and

talk. The visitors image will remain on screen for 90 seconds or until you put the handset down.

After speaking with the visitor, you may choose to open the door for them. To do this press the unlock

button. Note: You must have an electronic door strike installed in your system for this button to operate.

If you have two base stations installed in your sytem, you can press the call button to communicate with

the second location. This is ideal for two storey or larger homes as an internal intercom.

VIDEO DOOR INTERCOM SYSTEM

Stand by

OFF

Fig 2. Outdoor Camera Unit

1. Camera

2. Microphone

3. Infra-Red LEDs

4. Speaker

5. Call button

Page 3