Artison RCC600-SA Panduan Instalasi - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Penguat Artison RCC600-SA. Artison RCC600-SA 19 halaman. Subwoofer module | freestanding subwoofer | subwoofer amplifier | cabinet mount
Juga untuk Artison RCC600-SA: Panduan Instalasi (13 halaman)

Halaman Cetak

RCC 600 CABINET MOUNT (RCC600-CM)

The RCC 600 Cabinet Mount is an accessory to the RCC 600 Freestanding Subwoofer. The

RCC600-CM allows the RCC600-FS to be hidden inside of any piece of furniture or built-in

cabinetry. The subwoofer is designed to fit snuggly inside the cabinet mount and direct the

subwoofer's energy down through the bottom of the cabinet and either directly into the room or out

through vents in the cabinet's baseboard.

INSTALLATION

1. Using the supplied Cut-Out Template mark the 12 mounting holes and the cut-out area.

2. Remove the cut-out by using the appropriate method for your application.

3. Mount the cabinet mount to the bottom of the cabinet via the 12 mounting holes in the mount.

Drywall screws approximately 2.5" long are needed to secure the mount or use hardware that

is more appropriate to your application.

VENTING SPECIFICATIONS

When venting the output of the subwoofer through a built-in cabinet's baseboard, please

reference the points below:

a. Please allow for a minimum of 80 in

of total open area in the baseboard. If less open area

is provided the subwoofer will be restricted and may cause excessive noise through the

vent.

b. Rounded corners will also minimize noise caused by the excited air.

c. Either multiple smaller vents or one large vent can be used. The subwoofer is not affected

by variations in shape or number of vents, as long as the minimum total open area is

maintained.