AluTeam BR 13x-3 Manual Petunjuk Perakitan - Halaman 9

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Truk AluTeam BR 13x-3. AluTeam BR 13x-3 14 halaman. Box kits

Halaman Cetak

LED strip left

MA 350081

SML MA 350135

Connector cable MA 350081

Connection cable MA 350161

Blind cap pin MA 350093

MA 350172

MA 350173

in the frame

pillar

Fig. 361

Fig. 363

Fig. 364

Assembly instructions BR 133-3 to 139-3

LED strip right

MA 350081

Fig. 353

1+2

Connection

cable

MA 350081

Fig. 354

Fig. 355

Fig. 362

Fig. 365

For the cabling of the LED strips

•

frared sensor), just connect

connection downward into the left frame pillar (Fig. 353).

Remark: The illustration indicates a cabling with LED strips on the

right and left.

•

For the cabling of the preassembled side marking lights (SML), just

connect

the plug on the left side with the connection cable in

the floor profile and

with this cable as well.

Now insert the plug connections no.

on the front or on the side (Fig. 354); see also 3.9 (Fig. 396).

For the reversing camera MA 350172 or MA 350173, connect

•

camera cable in the frame pillar with that of the camera and slide

the plug connection into the pillar (Fig. 355). Then

cable MA 350174 into the driver cab in order to connect it to an

external monitor or via an adapter cable to the vehicle display.

Attention:

Be sure to follow the assembly instructions of the

camera manufacturer, as well as the specifications of

the chassis producer.

3.6 Assembly of the frame, doors, top gate or sliding door

•

Fix the lower cross beam from the outer side of the corner pillars

each with 2 screws M 10 x 60 mm. Do not tighten the screws yet!

Measure the diagonals of the frame and correct these as appropri-

ate until they are in full alignment (Fig. 361).

•

Tighten the screws of the frame nodes M 10 x 20 (MD 100332) and

the bottom frame cross beam screws M 10 x 60 (MD 100328) with

the correct torque (no impact screwdriver!). The cross beam and

the rear surfaces of the pillars must be flush (Fig. 362).

•

Take the fittings out of the roof assembly strips.

•

Close the tailgate in order to check the fit accuracy.

Set these up as appropriate, according to the door design, over the

brace supports on the frame cross beams.

•

Fix an upper flap to the frame using the holes provided in the hinge

with the screws MD 100058. Then seal the transitions (Fig. 363).

Take the gas pressure springs (piston rod must point down) and

engage the spherical heads.

•

In the case of a frame pillar with integrated seal, secure the flap

against lateral displacement with the assembly screws

•

In the case of a frame pillar without integrated seal, secure the flap

against lateral displacement with 2 brackets

•

Mount a sliding door according to the current instruction included

with the assembly material for sliding doors.

Status 03/2022

Former instructions lose their validity.

without

motion detectors (in-

the plugs and slide

connect the plug on the right-hand side

and

into the floor profile

(Fig. 365).

the plug

the

route the

(Fig. 364).

9 / 14