Alvin BPR026 Petunjuk Pengaturan & Penggunaan - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Pengaturan & Penggunaan untuk Rak dan Dudukan Alvin BPR026. Alvin BPR026 2 halaman. Mobile pivot rack

Halaman Cetak
Slide springs ( K ) on end of pivot brackets ( E )
5
as shown in Figure 5.
K
x12
Figure 5
Starting with the top hole, insert one pivot bracket into
6
back panel as shown in Figure 6. Once bracket is in top
hole, lift up to compress spring enough to allow bracket
to fit into bottom hole.
It is best to adjust rack before installing any other
brackets. Please follow "Height and Depth Adjustment"
instructions at this time.
Figure 6
Attaching Clamps to Pivot Brackets:
With open end of pivot clip facing rack, hold
1
clamp at approximately a 15° angle and slide
under top plate, as shown in Figure 7.
Top
Plate
Figure 7
Limited Lifetime Warranty
Alvin & Company warrants its Blueprint Racks to be free from defects in workmanship and materials under normal use for the lifetime of the product for as long
as the original purchaser owns it. Should service be required by reason of any defect or malfunction, Alvin will repair, provide replacement parts, or at its discre-
tion, replace the product without charge subject to verification of the defect or malfunction. This warranty is valid only if the product is used for the purpose for
which it was designed. It does not cover products that have been damaged by negligence, misuse, or accident or which have been modified or repaired by unau-
thorized persons. Coverage is at Alvin's discretion, subject to verification. Please refer to Alvin's website www.alvinco.com for additional information and details.
©2012 Alvin & CompAny, inC. • P.O. Box 188, Windsor, CT 06095-0722
Phone: 860-243-8991 • Toll-Free: 800-444-2584 • Fax: 860-242-8037 • Toll-Free Fax: 800-777-2896
E
x12
Pivot
Clip
Continue sliding clamp towards back panel until leading
2
edge of top plate is fully inserted beneath pivot clip spring,
as shown in Figure 8.
Top
Plate
Figure 8
Push down on front of clamp until it's level with top plate,
3
then pull towards you, as shown in Figure 9. Top plate will
slide beneath rear wing nut to lock clamp in place.
Rear Wing Nut
Figure 9
To remove clamp from pivot bracket, reverse procedure
4
described above.
Height and Depth Adjustments:
This rack is capable of holding documents from 18" x 24" up to
36" x 48". It must be adjusted to the documents being used.
Attach clamp to pivot
1
bracket with documents
hanging from it, as
shown in Figure 10.
Loosen hex bolts
2
holding front U
frame and slide
until front of frame
is positioned beneath
front edge of document.
Retighten securely.
Five holes are provided
3
for height adjustment.
Loosen adjustment
knobs and set rack to appropriate height for document
length, as shown in Figure 10. Retighten adjustment
knobs securely.
Now that height and depth have been set, securely tighten
4
the 4 Allen bolts that hold the back crossbar to the side
frames and install remaining pivot brackets.
Pivot
Clip
Spring
Figure 10
www.alvinco.com
LIT-A12055 5/12