ASI MFC2000 Operasi - Halaman 18
Jelajahi secara online atau unduh pdf Operasi untuk Pengontrol ASI MFC2000. ASI MFC2000 19 halaman.
Last update: 2021/12/20 16:41
Indoor use only
ms2000, manual,
0-10v
1)
If you do not see "Ports (COM & LPT)" when the drivers are installed and the controller connected and
powered up, then the computer may not fully support USB and RS-232. Certain inexpensive laptops
have been observed with this defect. The workaround solution for this problem is to use a Serial Port
PCI Card. Alternately, your computer may work with a Keyspan USA19HS High Speed USB / Serial
Adapter. This device, a cable with two connectors, plugs into your USB port, and the other end is a
serial port connector. With either the Keyspan or the Serial Card, you connect the device to the
controller via a serial null modem cable. A serial null modem cable is furnished with each ASI
controller and widely available at computer stores. Note that if the words "NULL MODEM" are not
stamped on the connectors of a serial cable, it is probably not a null modem cable.
From:
https://asiimaging.com/docs/
Permanent link:
https://asiimaging.com/docs/ms2000_operation
Last update: 2021/12/20 16:41
https://asiimaging.com/docs/
ms2000_operation
WARNINGS
1.
Ensure power switch is in the OFF position before
plugging in the power cord.
2.
Do not unplug or plug-in devices / cables when power
is on.
3.
Do not remove the cover; no user serviceable parts are
inside.
4.
For indoor use only.
5.
Keep clear of moving equipment. ASI Stages have
current limits on the motors to prevent excessive
traveler force from doing permanent bodily harm, but
pinches can still be painful.
6.
Protection provided by the equipment may be impaired
if the equipment is used in a manner not specified by
ASI.
7.
In the event of device failure, contact ASI: (541)
461-8181
(800) 706-2284
International: 011-541-461-8181
- Applied Scientific Instrumentation
https://asiimaging.com/docs/ms2000_operation
Printed on 2022/03/16 04:45