Askluft Storm Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Generator Portabel Askluft Storm. Askluft Storm 10 halaman.
Halaman Cetak
ÖVRIGT
FUNCTIONAL DESCRIPTION
Åskluft's ozone generators generate ozone by elect-
rical discharges converting the oxygen in the air to
ozone. Ozone, in turn, is a highly reactive gas that
reacts with, and oxidise the substances that produce
bad odours. The ozone that is not consumed in this
process decomposes on its own and eventually rege-
nerates into oxygen. It should be expected that this
process will take at least two hours.
The electrical discharge takes place against insulators
in the form of ceramic plates. In all our models, these
tiles have a long service life, about 8 000 hours.
PRODUCT WARRANTY
Åskluft's ozone generators are of high quality, and
we guarantee their function for 3 years from the date
of purchase for its original buyers. If errors still occur
within this period, Åskluft will remedy these errors.
Depending on the nature and extent of the defect, this
can be done either by repair or by replacing a new
corresponding item.
The warranty only applies to products that have not
been subjected to careless use, misuse, modifica-
tions, accidents, failure to perform maintenance that
is specified in the operating instructions, normal wear
or repairs not performed by an authorized repairer. All
PROBLEM
The mashine does not start
The display doesn't light up
Reduced capacity
The mashine does not work
* The fuse is located in a holder just below the electrical outlet. Use a small screwdriver or similar to push out the holder. A replacement
fuse is included and is also stored in the holder. If you need a new fuse, you will find the specification in the technical description in this
manual. If you are unsure of how to make the fuse change, please contact us at Åskluft.
other warranties are excluded. Åskluft is not respon-
sible for consequential damage to person or property,
other than what is regulated by law.
CERTIFICATION
and
CONTACT US:
POSSIBLE CAUSE
Power cable not
connected correctly
The fuse has blown
The mashine has not started
The ozone plates are dirty or
consumed
The ozone plates are consumed
Åskluft is CE marked and complies
with the R & TTE Directive (1999/5 / EC),
the EMC Directive (2004/108 / EC), and
the LVD Low Voltage Directive (2006/95
/ EC) issued by the EU Commission.
Directive 2002/95 / EC (RoHS)
prohibits the use of mercury, cad-
mium, lead, hexavalent chromium
the flame retardants PBB and PBDE in
new electrical and electronic products
placed on the market from 1 July 2006.
EU Directive 2012/19 / EU (WEEE) on is
taken from producer responsibility.
The product must be collected
separately and must not be disposed
of in normal waste.
+46(0)70-642 43 11
SOLUTION
Check that the power cord is
connected correctly
Replace the fuse*
Press Power
Contact Åskluft
Contact Åskluft for replacement
10