Asko D3530FI Panduan Petunjuk Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring Asko D3530FI. Asko D3530FI 12 halaman. dishwaher
Halaman Cetak
ELECTRICAL CONNECTIONS
WARNING!
Before working on wiring for any
electrical appliance, be sure the electrical power
has been turned off at the breaker/fuse box.
WARNING!
D i s c o n n e c t
supply and place a tag at the disconnect switch
indicating that you are working on the circuit.
WARNING!
E l e c t r i c a l
c o n n e c t i o n s m u s t c o m p l y w i t h t h e a p p l i c a b l e
p o r t i o n s o f t h e n a t i o n a l e l e c t r i c a l c o d e a n d / o r
other local electrical codes.
The dishwasher comes with an electrical
cord for 110-120 volts, 15/20 amp supplied.
This cord should be plugged into the 110-
120 volt outlet under the sink.
If the cord is not long enough, or if a hard-wire
installation is needed, follow instructions on page 8.
GROUNDING INSTRUCTIONS
This unit must be grounded to operate properly. It must
be connected to a grounded metal, permanent wiring
system, or an equipment-grounding conductor must
be run with the circuit conductors and connected to the
equipment-grounding terminal or lead of the appliance.
PREPARING THE DISHWASHER FOR INSTALLATION
At this point the styrofoam, plastic wrap, and the wood
pallet (base) should be removed from the dishwasher.
Now is an excellent time to inspect for any shipping
damage. Should you find any damage, you should
report it to your dealer or builder immediately.
Be sure to remove the toe kick and toe kick insulation
which are wrapped in heavy brown paper and packed
inside or on top of the dishwasher.
SLIDES FOR LEGS
The unit comes with white plastic slides for the legs to
protect the kitchen floor from being damaged when you
slide the unit into place. The slides simply snap onto
the bottom of the legs.
Protective slides for legs
simply snap onto the bottom
of the legs.
Page 6
e l e c t r i c a l
p o w e r
a n d
g r o u n d i n g
WARNING!
Do not use an extension cord for this appliance.
NOTE: Access holes should be 1-1/2" to 2" (38 mm
to 50 mm) in diameter with no sharp edges.
Damage to the dishwasher could occur if it is not
properly grounded.
WARNING! Make sure the water supply line,
drain line and branch circuit wiring do not touch
any exposed terminals of dishwasher wiring.
THE FILL STRIPS
All standard ASKO dishwashers (Models D3120, D3250,
D3350, D3530) have color-coded fill strips to finish off
the installation. To prevent damage to the machine, be
sure to remove the shipping screws that secure the
fill strips to the access panel. These screws are to be
thrown away. Do not replace them into the access
panel.
Lower Access Panel
If the cabinet opening is European measure-
NOTE:
ment (23-1/2 inches [597 mm]), remove the ll
strips to fit the dishwasher into the opening.
WARNING!
Do not screw the fill
strips back to the
lower access panel;
otherwise, the
machine will have to
be uninstalled if
service is necessary.
Fill Strip