Asko TD75 Panduan Petunjuk Instalasi - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Asko TD75. Asko TD75 13 halaman. Condenser tumble dryer
Juga untuk Asko TD75: Petunjuk Pemasangan dan Panduan Pemilik (12 halaman)

Halaman Cetak

3. Use the strain relief attached below the terminal

block opening.

4. Loosen or remove center terminal block screw.

5. Connect ground (center) wire of power supply

cord to the center, silver-colored terminal screw.

Tighten screw.

6. Connect the other wires to outer screws.

7. Tighten the strain relief screws.

8. Replace terminal box cover on back of dryer.

9. Plug dryer into wall receptacle.

10.Turn power on at breaker/fuse box.

Connecting a 4-wire Power Cord

Before starting this procedure, be sure the

power is turned oﬀ at the breaker/fuse box.

4-Wire Cord

3/4" UL-listed

Neutral

strain relief

Ground

prong

Power Supply Cord

You will need a 4-wire power supply cord with

four No. 10 copper wires and a matching 4-wire

receptacle of NEMA Type 14-30R, as illustrated

below. The fourth wire must be identiﬁ ed with a white

cover and the ground conductor by a green cover.

To connect a 4-wire power cord to the dryer, follow

the steps below.

The numbers in the illustration correlate to the

step numbers.

1. Turn the power oﬀ at the breaker/fuse box.

Spade terminals with

upturned ends

Ring

terminals

Neutral

(White)

Ground

(green)

Customer Care Center, 1-800-898-1879, www.askousa.com

2. Remove terminal block cover.

3. Use the strain relief attached below the terminal

block opening.

4. Remove center terminal block screw.

5. Remove ground wire (green with yellow stripes)

from external ground connector screw and

remove from center terminal block.

6. Connect ground (green) wire of cord to external

ground conductor screw.

7. Connect neutral (white) wire of cord under center

screw of terminal block.

8. Connect the other wires to outer screws.

9. Tighten the strain relief screws.

10.Replace terminal box cover on back of dryer.

11.Plug dryer into wall receptacle.

12.Turn power on at breaker/fuse box.