Aero-Spa Aero-pool Manuale di installazione - Pagina 10

Sfoglia online o scarica il pdf Manuale di installazione per Vasca idromassaggio Aero-Spa Aero-pool. Aero-Spa Aero-pool 13.

1. This occurs when the water used to fill the pool is hard. Using

a sponge or "Scouring pad" pad, wipe surface to remove

scale. Care should be used if using a "Scouring pad" pad to

ensure the surface of the pool is not damaged.

2. If these steps do not solve the problem call Aero-Spa, LLC

Light brown material on surface of pool walls

1. This occurs when the water is not adequately circulated in the

pool. Using a sponge, wipe surface to remove scale.

2. Increase pool circulation pump cycle time. Synchronize

circulation pump and Aero-Pool™ run time.

3. If these steps do not solve the problem call Aero-Spa, LLC

Water back siphoned into the ozone tube and or the ozone

1. A small amount of moisture can be considered normal in high

humidity conditions and in such a case nothing needs to be

done. If there is more than a few drops proceed to step 2.

below

2. Turn off all power by unplugging Aero-Pool from the 120 volt

power outlet. Remove the sintered diffuser from the pool and

lay it on the ground at a lower elevation than the generator.

Allow the unit to purge the water from the ozone tube. When

complete, reinstall sintered diffuser in pool and make sure the

air line is installed as described in the installation procedure.

3. If these steps do not solve the problem call Aero-Spa, LLC

Light scale on surface

generator