AMERICANA PERGOLA Manuale di istruzioni per il montaggio - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Tenda AMERICANA PERGOLA. AMERICANA PERGOLA 11.

STEP 4 - OPTIONAL COLUMN KITS: FIBERGLASS COLUMN
NOTE: Before installation, fiberglass columns must be painted. See below for color matching formulas.
TIP: Before painting, sand the column lightly with 120 grit or finer wet/dry sandpaper. Use mineral sprits to remove all dust/dirt.
-Start by measuring the required height of the column. If needed, trim off the bottom of the column.
-Cut a notch on opposite sides at the top of the column 3" wide and 2" deep (see Fig. 4-11). This is to allow room to attach
the post to the post top bracket. The notches will be covered by the column cap.
-Slip the top and base column caps on the column. The top column cap may rest on the neck mold.
-Place the post inside the column and mark the exact mounting location. Apply construction adhesive on the ground in the
area the bottom column cap will be. Continue with the proper option, depending of post mounting method.
3"
Fig. 4-11
Option 1 - If your pergola is surface mounted, anchor the post mounting brackets to the surface as shown in Fig. 1-2 or Fig. 1-3.
Prop up the column using any type of support block as show in Fig 4-12. Let the post slide down and attach to the post
mounting bracket as shown in Fig. 1-2 or Fig. 1-3. Remove the support blocks and anchor the bottom column cap.
Option 2 - If you plan to bury the posts, do so as instructed in Step 1 (see Fig. 1-4). Once posts are installed, hoist the column
over the post and place around it. WARNING: Standard 8'-0" x 8" round fiberglass column weighs approximately 60 pounds;
installation may require more than one person. Apply construction adhesive to the bottom surface of the column and anchor
the bottom column cap.
-Once columns are installed, continue with installation from Step 2. After the header is attached (see Step 3), raise the top
column cap and attach to the column plate using (4) #8 x 3/4" HWH #2 Tek screws (see Fig. 4-13).
Fig. 4-13
Top Column Cap
2"
Neck Trim
Column
Header Assembly
Column Plate
#8 x 3/4" HWH
#2 Tek Screw
Top Column Cap
Column
Column
Bottom Column Cap
3" Sq. Post
Temporary
Support
Post Mounting
Bracket
Fig. 4-12
Color Matching Formulas
Lowes - Valspar Paint 1 gallon
Exterior/Latex/Semi Gloss/Daylight
White
Base B1-20015
101 - 5 shot
103 - 1/2 shot
107 - 4 shot
Adobe (Clay)
Base B1-20036
101 (1y oz) - 45 1/2 shot
104 (1y oz) - 12 1/2 shot
111 (1y oz) - 32 shot
Wicker
Base B1-20015
101 - 18 shot
107 - 25 1/2 shot
109 - 3 1/2 shot
Latte
Base B1-20015
101 - 37 1/2 shot
107 (2y oz) - 19 1/2 shot
109 - 17 1/2 shot