Astralpool 25462 Manuale di installazione e manutenzione - Pagina 3
Sfoglia online o scarica il pdf Manuale di installazione e manutenzione per Pompa dell'acqua Astralpool 25462. Astralpool 25462 16. Self-priming pump for pools
Stampa la pagina
IMPORTANT SAFETY, INSTALLATION
AND MAINTENANCE INFORMATION
This instruction manual contains essential information on the safety
measures to be adopted during installation, maintenance and start-
up. Therefore, both the installer and the end user must read all of these
instructions very carefully before beginning the installation and start-up.
The manual can be downloaded in PDF format at:
www.astralpoolmanuals.com.
• The appliance described in this manual is specially designed for the pre-filtering
and recirculation of water in swimming pools, with clean water at temperatures
that do not exceed 35 ºC.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should
be supervised to ensure that they do not play with the appliance.
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of ex-
perience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children must not play with this appliance. Cleaning and mainte-
nance must not be carried out by children without supervision.
• Our pumps may only be assembled and installed in pools compliant with
standards IEC/HD 60364-7-702 and required national rules. The installation
should follow standard IEC/HD 60364-7-702 and required national rules for
swimming pools. Consult your local dealer for more information.
• If a self-priming pump is to be fitted above the water level, the pressure
differential to the pump suction pipe should not be higher than 0.015 MPa
(1.5 mH2O). Ensure that the suction pipe is as short as possible as a longer
pipe would increase suction time and the installation's load losses.
• The pump is intended to be used while fastened to a support or while
secured in a specific location in a horizontal position.
Installation and general maintenance manual
- SELF-PRIMING POOL PUMPS
3