Dafra DRPB48 Manuale operativo - Pagina 4

Sfoglia online o scarica il pdf Manuale operativo per Strumenti Dafra DRPB48. Dafra DRPB48 10. Pneumatic blind rivet setting tool

DRPB48 Operation Manual

2) Connect the air supply and to place a cloth over the hole where the screw (#9) was removed,

then to pull the trigger (#43) and the oil will be forced out from the tool;

3) Screw the oil inject adaptor (in oil injector set in the accessories pack) into the hole where

screw (#9) was removed;

4) Use the oil injector (in the accessories pack) to slowly inject the oil until full (approx. 15ml).

Remove the injector and its adaptor, then clean off any excess oil on the tool and tightly

screw the screw (#9) back into the tool;

5) Test the tool stroke. If the stroke is still not what it should be, some air could have entered

the oil cylinder (#11) while refilling the oil in the tool. To release this extra air from the tool,

connect the tool to the air supply, pull the tool trigger (#43) 6 or 7 times, then loosen the

screw (#9), to let the extra air leak out and then tighten the screw (#9) again.