AmpliVox SW800-96-02 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti AmpliVox SW800-96-02. AmpliVox SW800-96-02 12. Titan wireless battery powered pa system

Stampa la pagina

WIRELESS HANDHELD MICROPHONE

•

Frequency Set Button (R)

•

Channel Display / Battery Meter (S)

•

Select Buttons - Manual Channel Selection (T)

•

Power Indicator (U)

•

Power Switch (V)

HANDHELD MICROPHONE BATTERY INSTALLATION

• Press latch on ANTENNA CAP (W) and slide off. Must re-

move first to get BATTERY COVER (Y) off.

• Press latch on BATTERY COVER (Y) and slide off.

• Insert 2 AA 1.5V Alkaline Batteries. Observe proper

polarity when inserting. Insert (-) negative end of battery first

into opening. Install the second battery.

• Slide BATTERY COVER back on until it locks into place.

• Slide ANTENNA CAP back on until it locks into place. You

have been supplied three color caps besides the black cap

to choose from. Allows you to use a different color for identi-

fication when you have more then one handheld micro-

phone.

WIRELESS MICROPHONE CHANNEL SETUP

• Press POWER SWITCH (V) and hold 2-3 seconds to power

on the microphone. The POWER INDICATOR (U) will light

and CHANNEL DISPLAY (S) will show ON. To automatically

sync to the same channel that appears on the wireless panel

receiver press SET Button (R) and then press SYNC button

on Receiver Panel (D). Both displays will FLASH and sync to

the same channel.

• To manually select a CHANNEL first press and hold the SET

BUTTON (R) until the channel number begins to flash. Then

using the UP / DOWN BUTTONS (T) select channel that ap-

pears on the Receiver Panel (A). Press SET BUTTON (R) to

lock in channel number. Channel numbers must match for the

wireless microphone to work. To see the frequency that the

channel is on you can press and hold either the UP or Down

button.

T U

Latch

•

Antenna Cap (W)

•

Sensitivity / Mute Switch (X)

•

Battery Cover (Y)

OPERATION

• Check BATTERY METER in the CHANNEL DIS-

PLAY (S). Strong batteries are needed for good

transmission to receiver. When battery meter shows

only one bar you should replace batteries. If no bars

are showing, indicating that the batteries are ex-

hausted, display will flash three times and then auto-

matically turn off.

A fresh set of quality batteries will last approximately

8 hours.

• SENSITIVITY / MUTE SWITCH (X): If you are a soft

spoken person then set the switch to the HI position.

If you are a loud speaking person then set the switch

to the LOW position. Adjust to prevent distortion

while speaking.

MUTE : If you temporarily want to silent the micro-

phone without turning it off, slide switch all the way

down to MUTE microphone. When ready to use mi-

crophone again, slide switch to HI / LOW position

and begin to speak.

• When done speaking, press and hold POWER

SWITCH (V) for 2 seconds until you see the word

OFF in the CHANNEL DISPLAY (S). The micro-

phone is now OFF. POWER INDICATOR (U) will go

off when power switch is released.

Latch