Bosch DISHWASHER Manuale di istruzioni per l'installazione - Pagina 10

Figure 12

Junction Box

Dishwasher Preparation

Junction

Box Cover

Figure 13

Figure 14

DISHWASHER PREPARATION (continued)

Removing the Toe Panel

Regular Toe Panel

The toe panel is loosely attached with tape. Remove the

tape and pull the toe panel away from the dishwasher. Set

the toe panel aside. It will be reinstalled later.

SHY66 and SHX99A Base and Toe Panel

The base and toe panel are in place on the dishwasher, but

are not attached. Remove the toe panel first, as shown in

Figure 12, letter A, then remove the base, as shown in

Figure 12, letter B

Installing the 90° Elbow Fitting

NOTE: The 90° elbow fitting is not supplied with the

dishwasher, and must be purchased separately. If the

dishwasher's hot water supply line is to be copper tubing,

make certain the elbow has a compression fitting.

Apply Teflon tape or other pipe sealant when required.

Orient the hot water supply connection leg of the elbow

toward the channel opening in the dishwasher base.

Junction Box Preparation

1) Remove junction box cover, Figure 13, by lifting the

junction box cover up and off.

2) Remove the strain relief plate by removing the screw at

the back of the junction box, as shown in Figure 14, letter

D and sliding the strain relief plate out.

3) Set the junction box cover, strain relief plate, and screw

aside. They will be re-installed later.