Bosch DISHWASHER Manuale di istruzioni per l'uso - Pagina 14

Stampa la pagina

Bosch DISHWASHER Manuale di istruzioni per l'uso

aus

Optical display while the

programme is running *

* depending on model

While the programme is running, a light

spot shines on the floor under the

appliance door. Do not open the

dishwasher door until the light point is no

longer visible on the floor.

If the appliance is installed at eye-level,

with flush furniture front, the light point is

not visible.

This function can be changed as follows:

– Open the door.

– Switch on ON/OFF switch (.

– Hold down programme button # and

press START button h until : .... is

indicated on the digital display.

– Release both buttons.

– Press programme button # until the

factory set value :

the digital display 8.

To change the setting:

– By pressing the button 3, you can

switch the function off :

– Press START button h.

The set value is saved.

– Close the door.

Remaining running time display

When the programme is selected, the

remaining running time of the programme

is indicated on the digital display 8.

The running time is determined during the

programme by the water temperature, the

number of utensils as well as the degree

of soiling and may vary (depending on the

selected programme).

is indicated on

or on

Timer programming

You can delay the start of the programme

in 1 hour steps up to 24 hours.

– Open the door.

– Switch on ON/OFF switch (.

– Press the button X + until

flaching in the timer programming

display P.

– Press + or – button until the X

displayed time corresponds with your

requirements.

– Press START button h, timer

programming is activated.

– To delete timer programming X,

press the + or – button until

indicated on the digital display P.

You can change your programme

selection at any time until the

programme starts.

– Close the door.

End of programme

The programme has ended when the

value :

is indicated on the numerical

display 8.

The end of the programme is also

indicated by an acoustic signal. This

function can be changed as follows:

– Open the door.

– Switch on ON/OFF switch (.

– Hold down programme button # and

press START button h until : .... is

indicated on the digital display.

– Release both buttons.

– Press programme button # until the

factory set value :

the digital display 8.

To change the setting:

– Press programme button 3. Each

time the button is pressed, the set

value increases by one level; when the

value of :

has been reached, the

display jumps back to :

– Press START button h, the set value

is saved.

– Close the door.

is indicated on

(off).