Alemlube G10040N Manuale tecnico del proprietario - Pagina 3
Sfoglia online o scarica il pdf Manuale tecnico del proprietario per Strumenti Alemlube G10040N. Alemlube G10040N 7. 18v lithium-ion cordless grease gun el-series
Stampa la pagina
18V Lithium-ion Cordless Grease Gun
CHARGER OPERATION
Before using Grease Gun for the first time, the battery pack should be charged for 2 hours. If the battery is installed in
the gun, remove it by depress the one battery release button (on the back of battery) and pull battery pack out of gun.
As a battery approaches the discharged state, you will notice a sharp drop in tool performance. When the tool is
unable to perform the task at hand, it is time to recharge the battery. Recharging the battery before this condition is
reached will reduce the total work life of the battery. Discharging the battery beyond this point can damage the battery.
NOTE: Battery temperature will increase during and shortly after use. Batteries may not accept a full charge if they
are charged immediately after use. Allow the battery to cool to room temperature before charging for best results.
When the battery requires recharging, a 1-hour charge allows the tool to operate at full power. Do not recharge the
battery longer than 1 hour, as damage to the battery and/or charger will occur.
Insert the battery into the charging socket of the charger. Then, plug the charger into the nearest 230 volt, grounded,
electrical outlet.
CAUTION:
Vent slots in top and bottom of charger must not be obstructed.
Do not charge battery when temperature is BELOW 0ºc or ABOVE 40ºc.
NORMAL CHARGING
Make sure power circuit voltage is the same as that shown on the charger specification plate.
Connect charger to power source.
The first charge should be for 2 hours before use. Insert battery into charger. The red light should glow indicating the
battery is charging. After about 1 hour, the red light goes out indicating a fully charged battery; the green charge light
glow indicating that the charger has switched to trickle charge mode. The battery may be left on the trickle charge until
you are ready to use. Disconnect charger from power source when not in use.
INSTALLING OR REMOVING BATTERY
TO REMOVE BATTERTY:
Depress the battery release button (on the back of battery) and pull battery out of grease gun.
TO INSTALL BATTERY:
Align battery with opening handle and push battery into handle so as to lock it in the place.
NSW
QLD/PNG
TEL: (02) 9939 0711
TEL: (07) 3204 9166
FAX: (02) 9939 0411
FAX: (07) 3204 1224
Visit our website at
Charger Operation G10040N
Charging the Battery General
VIC/TAS
TEL: (03) 8787 8288
FAX: (03) 8787 8266
www.alemlube.com.au
WA
SA/NT
TEL: (08) 9209 3066
TEL: (08) 8241 7111
FAX: (08) 9209 3933
FAX: (08) 8241 7011
Email - [email protected]
NZ
TEL: (09) 447 1007
FAX: (09) 447 1008
3