Atlantic Technology IC-BOX-8 Istruzioni per l'installazione

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Supporto per TV Atlantic Technology IC-BOX-8. Atlantic Technology IC-BOX-8 1. Rough in kit information for iwts 6 cms and iwts 8 cms ceiling speaker

Stampa la pagina

Rough In Kit Information for

IWTS 6 CMS and IWTS 8 CMS

Ceiling Speaker

Installation Instructions

Preparation

Rough-In Wall And Ceiling Bracket The bracket is designed

to facilitate the installation of these speakers in new construction

projects.The bracket not only gives you a solid metal mounting frame

for extra support of the speaker, but also assures that the cut outs for

the speakers are of the proper size and location. The bracket is de-

signed so that the mounting arms will span studs or joists on either

16" or 24" centers. The flange may be oriented either in a horizontal

or vertical fashion.

Ceiling Speaker Back Box The installer must be certain

that there is sufficient room for the speaker back box and rough in

bracket and that lead wires and electrical conduit can be brought to

the planned location.1/2" conduit electrical knock-outs are provided

on all four sides of the back box for wiring convenience.

The following kits will be availble:

IC-NC-6 New Construction Kit for the 6 CMS.Includes two mount-

ing rails and a steel plate for locating the speaker in the wallboard.

IC-NC-6 New Construction Kit for the 8 CMS.Includes two mount-

ing rails and a steel plate for locating the speaker in the wallboard

IC-BOX-6/8 Back Box for either a 6 or 8 CMS speaker. The back

box mounts to the rails included with the New Construction Kit. The

appropriate kit must be ordered to install the back box.

Back Box Speaker

Enclosure

Rough In Bracket

Side Rails (2 pcs)

Assembly and Installation

Back BoxDimensions with Bracket:

15"W x 15-1/8"L x 6-1/2"D

If you are using a Ceiling Speaker Back Box, start with Step 1.

Otherwise, skip to Step 3 for Rough In Bracket assembly and instal-

lation.

#8 Philips Sheet

Metal Screw (2 pcs)

Attach the rough in bracket flange, tabs facing out, to the

enclosure with the (2), #8 sheet metal screws provided.

Punch out one of the 4 knock-outs on the side of the enclosure

to bring in the speaker wire and attach a 1/2" conduit nipple

if necessary.

Slide one side of the flange of the bracket (or bracket/box as-

sembly) into one of the mounting arms, making certain that

it seats all the way under the rolled-over edge of the arm.

Slide the other arm onto the opposite side of the flange.Make

certain the arms are located evenly on the flange.

Measure the mounting location of the bracket (or bracket/

box) assembly against the stud work and attach it to the

studs with nails or screws. Make sure the flange is facing

outward.

NOTE: The bracket (or bracket/box) assembly may be slid from

side to side on the arms after the bracket is mounted for final

position adjustment. Do not mount the assembly closer than

1-1/2" to a stud or joists to allow the clamping feet to swing

freely for clamping the speaker assembly in the wall or ceiling.

Route the speaker wire through the knock-out hole in the

back box and attach conduit if necessary to the installed

nipple.

After the sheet rock or ceiling tiles are installed,the mounting

hole for the ceiling speaker may be cut out and the speaker

installed as normal with the clamping feet securing the as-

sembly together.

343 Vanderbilt Avenue Norwood, MA 02062

(781) 762-6300 www.atlantictechnology.com

010-1082