Bose 201 Series IV Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Altoparlanti Bose 201 Series IV. Bose 201 Series IV 13. Direct/reflecting speakers
Anche per Bose 201 Series IV: Manuale d'uso (13 pagine), Manuale d'uso (12 pagine)

Stampa la pagina

Check

the connections

Check that all connections are made positive to positive (+ to +) and negative to negative

(- to -) (Figure 5). Make sure that no loose strands of wire touch across terminals. This

could damage your receiver or amplifier. Be sure the connections are secure before you

plug in the receiver or amplifier and turn it on.

Back of right speaker

,I,

Back of left speaker

Figure

Completed connections

Receiveror Amplifier

Test the speakers

To make sure your speakers operate correctly:

1. Place the speakers less than 6 inches (15 cm) apart, facing each other.

2. Turn on your receiver, and set it to MONO (monophonic), if that is an option on your

model.

3. Set the balance control to normal (center position).

4. Play some deep bass passages of music through the speakers.

The sound should seem to come from a point between the two speakers. The bass should

be full and natural. If it is not, one of the connections may be reversed, causing the speak-

ers to play out of phase. Refer to "Make the connections" on page 6. To correct the

problem, make sure all the wires are connected positive to positive (+ to +) and negative to

negative (- to -). Then repeat steps 1 through 4 to re-test the speakers.

_; i ii:ii!i

¸ _? i; ¸ '¸iii:i!!iii,_:ii!ii_

AM183562_04_ V.pdf

October 30, 2001