Alert Labs Flowie Manuale di avvio rapido - Pagina 4
Sfoglia online o scarica il pdf Manuale di avvio rapido per Accessories Alert Labs Flowie. Alert Labs Flowie 6. Water sensor
Stampa la paginaScrew in the antenna
1
Plug it into the wall
2
There's a power adapter in the box; plug one end of the adapter
into the wall and the other end into the sensor.
As soon as it gets power, your Flowie will wake up, and the status
light on top will come on. If the light is not on, then double check
that the sensor is plugged in properly and that the wall outlet and
any power bars or extension cords you're using are, in fact,
providing power.
While your Flowie should remain plugged in at all times, it has an
internal rechargeable battery that will keep it running for about a
day without power from the wall outlet. This provides
uninterrupted service in case there's a power outage or if your
Flowie gets temporarily unplugged.
Green light
3
As soon as you plug it in, your Flowie will search for a cellular signal.
Check the status light on top of the sensor; you want it to be green
which means it's found a good signal. This can take up to 2 minutes.
Green = Good Signal. Your Flowie has found a good cellular
signal, and is reporting its data. You're good to go to the next
step.
Red = No Signal. Your Flowie does not have a good cellular
signal which means it cannot report its data. To improve the
connection, try moving the antenna and wait at least 2 minutes
while it tries to connect from the new position. If it still can't find
a signal, you may need an extension antenna to improve
reception in your area. Visit alertlabs.com/support for details.
Yellow = Running on Battery. Your Flowie has a good cell signal
1
and is reporting its data. BUT... it is not receiving power from
the wall outlet and is running on its own internal battery. Check
your power connections to restore power. The backup battery
2
won't keep the sensor running for more than a day.
Off = No Power. If the light is off, then your Flowie is off and has
no power. It will be off when you receive it, but will wake up
when you plug it in. If it was working before, then it means it's
no longer receiving power and the backup battery is out of
charge. Plug it into a good power source to get it going.
Remove the installation
4
sticker
Your Flowie comes with a copy of these installation instructions
printed on a protective easy-to-peel sticker over the entire face of it.
You can remove the sticker now.
The sticker also has the serial number of the sensor printed on it.
You'll need that when you register your Flowie on the Alert Labs
Dashboard so don't throw it out.
ALERT LABS | PKG-000010-003