Bose Panaray 502A Manuale di installazione - Pagina 2
Sfoglia online o scarica il pdf Manuale di installazione per Altoparlanti Bose Panaray 502A. Bose Panaray 502A 12. Full-range-driver array loudspeakers
Anche per Bose Panaray 502A: Informazioni tecniche (4 pagine), Manuale (4 pagine), Manuale di installazione (24 pagine), Manuale di installazione (32 pagine)
Stampa la pagina
Safety Information
For Permanent Installation
WARNING: Permanent installations involve the attachment of the loudspeakers to brackets or other mounting surfaces
for long-term or seasonal use. Such mountings, frequently in overhead locations, involve risk of personal injury if either the
mounting system or the loudspeaker attachment fails. Installation of the mounting system must be performed in accor-
dance with all applicable building codes including local codes. Consult the local authority having jurisdiction before install-
ing this product.
Bose offers mounting brackets for the use of these loudspeakers in permanent installations. However,
we realize some installations may call for use of other, custom-designed mounting solutions or non-Bose mounting
products. While Bose Corporation cannot be held responsible for the proper design and use of non-Bose mounting
systems, we offer the following guidelines for the permanent installation of the Bose 502
• Obtain your mounting system from a reputable manufacturer, and make sure the system is specifically designed for
the loudspeaker of choice and your intended use.
• Before using a custom-designed and fabricated mounting system, have a licensed professional engineer review the
design and fabrication for structural integrity and safety in the intended application.
• Notice that all threaded attachment points on the back of each loudspeaker have a metric M8 x 1.25 thread with at
least 6 usable threads.
• Use a safety cable, separately attached to the cabinet at a point not in common with the load bearing attachment
points of the bracket to the loudspeaker.
• If you are unfamiliar with the proper design, use, and purpose of a safety cable, consult a licensed professional
engineer, a rigging professional, or a theatrical lighting trades professional.
CAUTION: Use only graded hardware. Fasteners should be metric Grade 8.8 minimum and should be tightened
using torque not to exceed 50 inch-pounds (5.6 Newton-meters). Overtightening the fastener could result in irreparable
damage to the cabinet and an unsafe assembly.
Do not re-tighten these fasteners unless they are visibly loose. Characteristics of the plastic cabinet may cause some
relaxation of tightening torque over time, which is normal. Lockwashers or a thread locking compound intended for hand
disassembly (such as Loctite
CAUTION: The fastener should be long enough to engage no fewer than 6 threads of the attachment point. Using
a fastener that is too short provides inadequate holding power and may strip the mounting threads, resulting in an unsafe
assembly. Confirm that at least 6 full threads are engaged in your assembly.
CAUTION: Do not attempt to alter the threaded attachment points. While SAE
appearance to the metric M8, they are not interchangeable. Do not attempt to re-thread the attachment points to accommo-
date any other thread size or type. Doing this will render the installation unsafe and will permanently damage the loud-
speaker. You may substitute
2
®
242) should be used for a vibration resistant assembly.
-inch washers and lockwashers for the 8 mm ones.
5
/
16
®
A loudspeaker:
-18 UNC fasteners are very similar in
5
/
16