Anywave TRN-U1D Manuale di avvio rapido - Pagina 9

Sfoglia online o scarica il pdf Manuale di avvio rapido per Trasmettitore Anywave TRN-U1D. Anywave TRN-U1D 16.

5 Initial Turn On

Please locate and have handy for reference a copy of your ACT TRN-U1D-C-FA

Factory Test Report as well as the ACT TRN-U1D-C-FA Quick Start Guide,

and PA-U1D-C-FA PA and Exciter User Manuals.

1. With all equipment turned OFF, please make the cable connections according

to the System Interconnect Diagram of section 4. Make sure the BPF or PA

output is properly connected to your Antenna feed or a suitable station load

before proceeding further.

2. Turn ON the Exciter via its rear-panel AC switch.

3. Check Exciter settings. Check the operating Frequency of the Exciter by

navigating to the Exciter FREQ submenu (simultaneously press Left and Right

buttons)

Check the Exciter drive level is set to -25dBm by navigating to the Exciter RF

submenu (from above, press ESC button then enter the RF submenu).

(Please refer to your Exciter User Manual for help with the detailed operation

of the Exciter).

4. Turn the PA ON via the PA rear panel breaker, which should turn BLUE when

ON.

5. The built-in FWD and REF power metering in your TX has already been

calibrated at the factory. The PA's touchscreen and its Web interface both

contain the System Forward and Reflected power meter readings FWD-POW

ACT-PA-U1D-QSG-DOC-V2.2, 09/25/2019

TRN-U1D-C-FA Quick Start Guide

Page 9 of 16