Anywire Bitty Series Manuale del prodotto - Pagina 4

Sfoglia online o scarica il pdf Manuale del prodotto per Cavi e connettori Anywire Bitty Series. Anywire Bitty Series 5. Poka-yoke terminal
Anche per Anywire Bitty Series: Manuale (15 pagine)

Anywire Bitty Series Manuale del prodotto
[How to Mount Fittings on the Pipe]
onto the hinge part of the
body.
Fitting B
Hinge part
Body
[How to Replace the Lever]
■Removal of Rubber Lever
(1) Push the black part of the retention ring for the
rubber lever in the direction of B and release the
1
Front View
2
LINK
4
8
16
32
64
128
ON
ADDRESS
View A
(2) Remove the rubber lever from the rubber lever
① → ②).
② Rubber lever
① Retention ring for rubber lever
and then pull the body to
make the connection. When
the body piece snaps into
made.
Body piece
ADDRESS No.
Retention ring for
rubber lever
A
Rubber lever
B
-A027XB02*2P 4/5-
Slide the body to adjust the
position.
1
2
4
8
16
32
64
128
■Mounting the Rubber Lever
(1)
boot section and place the retention ring over the rubber lever . Use a
new retention ring for the rubber leve r.
① New rubber lever
② New retention ring for
rubber lever
(2) Mount the retention ring for the rubber lever to the (D) position (Rubber
lever boot section) in the front view.
Fasten the outer circumference of the rubber lever boot section after
pushing the black mark part in the direction of C with pliers, etc., and
matching the stopper piece until D and E contact each other (Refer to F).
Front View
Example of
F
Once the position has been
pipe with the provided bolts.
M6 bolt fastening torque: 1.5 - 2 N-m
■Rubber Lever Set
for Replacement
Type:A027-LSE-01-5P
(5 sets)
Retention ring for
rubber lever
1
2
LINK
4
8
ADDRESS No.
16
32
64
128
ON
ADDRESS
Mounting position of
the retention ring
for the rubber lever (D)
B
Rubber lever
C
D
E
Hex socket bolt
(M6×15)
One bolt is attached
to the bod y.
Retention ring
for rubber lever
Outer circumference
of rubber lever
boot section
C
View B