Anzzi BA-LMDFX010AL Manuale di installazione e funzionamento - Pagina 7
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Prodotti per la cura della persona Anzzi BA-LMDFX010AL. Anzzi BA-LMDFX010AL 8. Front lighting led mirror
INSTALLATION INSTRUCTIONS
5
A
B
C
If drilling into wood, drill a 1/8" hole at each marked
location (figure A) and install screws into holes. If
drilling into concrete, drill a 5/16" hole at each marked
location (figure A, B, C), insert wall plugs, and install
screws into the wall plugs. Leave a gap of 1/4"-5/16"
between the screw head and the wall.
7
WIRING DETAILS
INCOMING SUPPLY
SWITCHED LIVE
EARTH(GREEN/YELLOW
SLEEVED COPPER)
NEUTRAL
Live wire
Earth wire
MIRROR WIRING
L
BLACK or LABELED - L
N
WHITE or LABELED - N
Twist-cap Connector
Neutral
wire
white wire
green
wire
LED Mirror
Cable
6
1/4" - 5/16"
The LED mirror is provided with a power supply cord.
For the plug-in connection, place the mirror against the
wall and slide down as shown. Then plug the power
supply cord into the outlet to finish the installation. For
the wire connection, please cut the power supply cord
near the plug and connect the wire by following step 7.
Then secure mirror by following step 6.
Before starting the wire connection, please make
sure the electricity supply has been turned off.
For the wire connection, please cut the power supply
cord and strip a section of sheath and insulation from
GREEN - E
the cable. Connect the neutral (N) and live (L) wires to
the mirror's power supply wires, using the Twist-cap
Connectors. Connect the mirror's green wire to the
grounding wire in the junction box with a Twist-cap
Connector. Carefully push the wires into the junction
box.
black
wire
A
A
B
B
5