Abus Secvest FU8006 Manuale rapido - Pagina 2

Sfoglia online o scarica il pdf Manuale rapido per Sistema di sicurezza Abus Secvest FU8006. Abus Secvest FU8006 2.

Stampa la pagina

Insert the batteries with the correct polarity.

Close the unused cable inputs using the plugs

provided.

Suspend the centre at the top of the base plate and

reconnect the ribbon cable to the connection in the base plate. Fold

the front housing side downwards and fasten it using the two housing

screws.

Attach the mains power supply to the centre.

IMPORTANT:

When starting the centre for the first time, you will

be prompted to select your language.

Secvest QuickGuide programming

Secvest

QuickGuide programming

There is a difference between the installer menu and user menu when programming the centre. A user code and an installer code are required. To access the installer menu, press

the key under the "Menu" display. Enter your installer code (7890

information can be found in the installation instructions.

Insert the batteries in the detector, then press the tamper contact on the detector (open). The centre acknowledges reception with a confirmation tone.

If a false alarm is triggered accidentally, then this can be acknowledged by entering the administrator code (1234

menu is accessed. This means that all detectors can be opened without triggering an alarm. Some examples of training detectors are found below. When other detectors are used,

consult the corresponding manuals for further information. Details on programming the zone settings can be found in the installation instructions.

Tamper contact

(wall break contact)

The user menu must be accessed in order to change user codes and train chip keys, wireless cylinders or remote control units. Leave the installer menu and access the user menu by

pressing "Menu", then entering the administrator code (1234

For example, select "Telecommands" in the menu to assign a remote control unit to this user. The SecvestKey wireless cylinder is also trained in this menu.

Press the key for

around 2 seconds

until the red LED

7890) and then the user code (1234

1234). Follow the instructions in the display to train the wireless detector. Detailed

7890

1234

Tamper contact

Front and

rear side

1234).

1234

Press the key for

around 1 second,

then turn the knob

1234). The system does not react to tamper messages when the installer

1234

Press the test

button for about

10 seconds