Aeware in.zone Manuale - Pagina 8

Sfoglia online o scarica il pdf Manuale per Spa Accessories Aeware in.zone. Aeware in.zone 14. Innovative corona discharge ozonator

in.zone

Installation schemes

The following material is recommended:

Two (2) # 10 screws of appropriate length with round, truss or pan

head and two (2) washers 1/2 OD x 1/16" thickness.

To install in.zone:

Select the most appropriate location on the ﬂ oor or the wall

(recommended) and ﬁ rmly attach in.zone to a wooden base with

(2) screws backed by (2) washers.

Note: If you choose to install in.zone on the ﬂ oor or close to the

ﬂ oor (not recommanded), it must be installed at least 4" above

it must be installed at least 4" above

potential ﬂ ood level. If ﬂ oor is on ground level, in.zone should be

raised at least 4".

Warnings and important notes

Important: Please note that countersunk screws should not be

used as they can damage in.zone base.

Attention: In.zone air intake should not be pointing up; it

should either point down or to the side to prevent water

inﬁ ltration.

Warning: Beware of some products commonly used against

corrosion (such as WD-40 family products). Their use, due to

negative chemical reactions between some industrial oils and

4" 4"

plastic, could damage in.zone's plastic enclosure. Any other

materials which may come in contact with its enclosure must be

carefully evaluated for compatibility.

air intake

air intake points

points to

to the ground

the side

installation

air intake

points up