Addvent AVAC9000W Istruzioni per l'installazione e manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso per Condizionatore d'aria Addvent AVAC9000W. Addvent AVAC9000W 9.

AVAC9000W[15]instructions

Installation

Exhaust Duct Set Assembly and Installation

Connect exhaust hose assembly to the back of the unit. Extend
supplied hose to desired length and locate the exhaust nozzle
through the window for ventilation.
G
Insert both ends of the exhaust hose into the two exhaust
nozzle connectors by twisting anti-clockwise until they stop.
G
Fix one of the connectors to the rear outlet of the unit.
This is achieved by sliding the nozzle connector downwards
over the exhaust outlet of the unit ensuring that the lugs on
the nozzle connector are engaged with the grooves on the
connector of unit.
G
Fix the other exhaust nozzle connector to the exhaust
nozzle.
G
Extend the exhaust hose and close the window as much as
possible trapping the exhaust nozzle.

Semi-permanent Installation

If required, your appliance can also be installed
semi-permanently.
G
Drill a 125mm hole in an outside wall* or through a
window pane.
G
The unit should not be within 300mm of any wall.
G
Fit the flange accessory fixture provided in the hole.
G
Fit the exhaust hose in the housing at the back of the
appliance.
G
Insert the other end of the exhaust hose to the flange
previously fit on the wall as shown.
When the hose is not in use, place the cap for connector to
cover the hole.
NOTE : When installing the air conditioner semi permanently,
you should leave a door slightly open (as little as 1cm) to
guarantee sufficient ventilation.
* Installing through an outside wall: you are recommended to
insulate the section of wall using suitable insulation material.
9/4/15
09:43
Page 6
6
Exhaust nozzle
Exhaust
hose
Exhaust nozzle
connectors (2)