Hifonics BRX5016.4 Manuale di installazione rapida
Sfoglia online o scarica il pdf Manuale di installazione rapida per Amplificatore Hifonics BRX5016.4. Hifonics BRX5016.4 2.
Stampa la pagina
Before you start
CAUTION
Many new and factory radios require a reset code when
disconnected from battery power. This is an anti-theft
feature. Before unplugging power, you must determine if
your radio/source unit requires a reset code. Check the
operation manual for your vehicle or contact the dealer.
Model
Power cable size
and fusing
BRX316.4
BRX616.4
It is critical to use the proper power
BRX1616.4
and ground cable. Select the size
BRX5016.5
listed here for your amplifi er model.
Always use high quality copper
BRX1116.1D
cable. Visit our website for multi amp
BRX1516.1D
system cable recommendations.
BRX2016.1D
Be sure to use the proper fuse size
BRX2416.1D
for each model. Some models require
an external fuse.
BRX3016.1D
Installation
1
Disconnect
negative battery
terminal
Place terminal in a secure
position so that it won't
accidentally contact the
negative battery post
2
Run Cables
Properly route power,
speaker and RCA cables
through the vehicle.
3
Mount Amplifi er
Choose a mounting location
that will provide adequate air
ventilation. Mount the amplifi er to
a secure surface. Do not mount
the amplifi er upside down.
4
Chassis Ground
The chassis ground connection
is critical to the performance
of the amplifi er. Choose a
location that is close to the
amplifi er. Completely scrape
away the paint and use a nut
and bolt if possible.
DO NOT USE AN EXISTING
FACTORY BOLT!
Fuse Size
Cable Size
5
Negative Power
Connection
2-25A atc
2-30A atc
2-60A Maxi
4ga
Attach the chassis ground
ext - 200A
cable to the amplifi er
negative terminal. It is
1-60A Maxi
important to make sure this
2-70A Maxi
connection is very tight.
ext - 200A
2ga
6
Remote Turn-on
ext - 225A
Connection
ext - 250A
Attach the remote turn on
wire to the amplifi er remote
output of the source unit.
7
Positive Power
Connection
Attach the main power cable
to the amplifi er +12V. The
cable must run directly to
the battery and be properly
fused and be very tight.
8
Signal Input
Connection
Connect the RCA cables to
the INPUT connectors. The
OUTPUT can be used to
provide input for a second
amplifi er.
9
Level Control
Bare metal
Turn the LEVEL control completely
counter-clockwise to minimum.
10
Speaker
Connections
Connect the speaker cables to
the speaker output connectors.
Follow the diagram below
that best fi ts your speaker
confi guration.
Stereo
Bridged
Monoblock
Monoblock
single woofer
11
Positive Battery
Connection
Connect the power cable to the
positive battery terminal. The
power cable must be fused
within 18 inches of the battery
terminal.
Be prepared to disarm your vehicle's alarm and
to enter your radio / source unit code.
12
Re-connect
Negative Battery
Terminal
Re-connect the negative
battery terminal making sure it
is securely tightened.
multiple woofers