Galvin Specialised Ezy-Drink TD45XP Installazione del prodotto Manualline - Pagina 2

Sfoglia online o scarica il pdf Installazione del prodotto Manualline per Prodotto idraulico Galvin Specialised Ezy-Drink TD45XP. Galvin Specialised Ezy-Drink TD45XP 4. Lead free ss316 45 push button drinking bubbler tap

Stampa la pagina

PRE-INSTALLATION - MOUNTING DETAILS

Note: Before installation, all lines must be flushed. We recommend that a line strainer be installed prior to drinking

taps to eliminate any foreign material

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions

and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical

supply conditions must also comply to the applicable national and/or state standards. Failing to comply with

these provisions shall void the product warranty and may affect the performance of the product.

1. Fit tap assembly

− Fit tap assembly to ½" BSP male connection

using thread tape or sealant to seal the inlet.

Ensure position is as shown; mouthguard to

be facing upward.

− Note: When applying thread tape or sealant

at the inlet, ensure the inlet is not obscured.

This is to prevent excess thread tape or

sealant blocking the flow regulator, affecting

the flow of water.

2. Testing

− Once the drinking tap has been installed and

− To adjust water flow:

−

Version 1, 15 April 2019, Page 2 of 4

tested for leaks, the water height must be

adjusted to suit the available pressure.

1. Remove the blanking screw 

2. Adjust the water height by turning the

regulator screw 

3. Replace blanking screw.

Note: The full range from minimum flow to

maximum flow is only ¼ turn.