Maiwe MIEN1203-F Manuale d'uso - Pagina 2
Sfoglia online o scarica il pdf Manuale d'uso per Interruttore Maiwe MIEN1203-F. Maiwe MIEN1203-F 5. Industrial ethernet switch
Stampa la pagina
Interface description
Take MIEN2205-F as an example
Ground screw
Power supply
Fiber port
DIN-RAIL kit
RJ45 port
Item
Crimp one end of the grounding screw with the cold-pressed
Ground screw
terminal. The other end of the grounding wire is connected to the
ground, and the grounding wire is not less than 2.5mm2
Support Dual DC12-48V or DC48 (36~72V).
Power interface
Support single power input AC85-264V or DC110-370V.
Supports automatic MDI/MDI-X connection. You can connect the switch
Ethernet RJ45 port
to terminal devices, servers, hubs, or other switches.
The 100M fiber port is a 100Base-FX full-duplex single-mode or
multi-mode fiber connector, which support single-fiber or dual- fiber
Fiber port
connectors, and the connector can be SC, ST or FC. The optical
fiber connectors must be used in pairs (TX and RX are a pair).
Din-rail kit
To fix the switch.
Description
The indicator description of the switch is shown in the following table.
Indicator lights
Status
On
The power is connected and operating normally
PWR1/PWR2
The power is not connected or the system is not operating
Off
normally
The system is operating normally (some models are always
Flashing
RUN
on to indicate normally)
Off
The system is not working properly
Fiber Port Status LED
On
The port has established a valid network connection
LINK
Flashing
There is network activity on the port
Off
No valid network connection is established on the port
RJ45 Port Status LED
Each RJ45 port has two indicator lights, the yellow light is the port plastic rate indicator, the
green light is the port connection status indicator.
On
100M working state (namely 100Base-TX)
10/100M
(Yellow)
Off
10M working status (namely 10Base-T)
On
The port has established a valid network connection
Link/Act
Flashing
There is network activity on the port
(Green)
Off
No valid network connection is established on the port
Definition
System Status LED