Maiwe MIGE2205G Series Manuale d'uso - Pagina 16

Sfoglia online o scarica il pdf Manuale d'uso per Hardware di rete Maiwe MIGE2205G Series. Maiwe MIGE2205G Series 20. Industrial gigabit media converter industrial ethernet switch

MIGE1203 Series Industrial Gigabit Media Converter/MIGE2205G Series
Industrial Ethernet Switch
Check the optical fiber terminator if it is clean. Slightly moisten a clean
paper towel or cotton ball, and gently wipe the cable plug. Dirty optical fiber
terminator will reduce the quality of optical transmission and affect port
performance
Connect one end of the optical cable to the optical interface, and the
other end to the optical interface of another device
After connection is completed, check the corresponding LINK/ACT
indicator of the optical port on the front panel. If the indicator is on, the
connection is valid.

3.3.3. Laying out cables

The cable layout must meet the following conditions:
Before laying out the cables, check whether the specifications, models
and quantities of all cables are in compliance with the construction drawing
design and contract requirements
Before laying the cable, check whether the cable is damaged, whether
there is a factory record and quality assurance certificate to prove its quality.
The specifications, quantity, routing direction, and location of the cables
to be laid should meet the design requirements of the construction drawings.
The length of each cable should be determined according to the actual
location.
Separate user cables and power cords
No broken wires or joints in the middle of the laid cables
Cables should be laid out neatly in the walkway, with even and smooth
Straight in the slot and not go beyond and block other cable inlet and
outlet holes. Tied and fixed at the cable exit or the cable bend.
Cables, power cords, and ground wires are placed in the same slot, no
overlap or mixed. If the cable is too long, please neatly placed in the middle of
the cable rack, and cannot be pressed on other cables.
Be careful knotting when laying pigtails and minimize the turning points
and the turning radius should not be too small. The lashing should be
moderately tight and not too tight. When laying on the cable rack, it should be
placed separately from other cables
Both ends of the cable should have corresponding marks, and the
content of the marks is concise and easy to maintain
Notice
Be careful knotting when laying pigtails and minimize the turning points
and the turning radius should not be too small to avoid serious loss of
optical signals and quality of communication.
- 12 -
link