Gamry Instruments EIS Box Manuale di istruzioni
Sfoglia online o scarica il pdf Manuale di istruzioni per Apparecchiature di laboratorio Gamry Instruments EIS Box. Gamry Instruments EIS Box 7.
Stampa la paginaIntroduction
About the EIS Box
The EIS Box (pronounced "ice box") is a value-oriented, research-grade
electrochemical instrument packaged in a small case. It is designed for
battery-testing via electrochemical impedance spectroscopy up to eight
cells.
The EIS Box excels at electrochemical impedance testing of small- to
medium-sized single-cell energy-storage and power-conversion devices.
Such devices include batteries, electrical double-layer capacitors, fuel
cells, and photovoltaic cells. The EIS Box can apply and measure currents
from 5 A to ~0.05 µA.
Features of the EIS Box include:
•
Six-decade current auto-ranging for large and small batteries,
•
Electrical isolation from earth ground, and
•
Both analog and digital filtering.
A sine-wave generator on the EIS Box allows the instrument to make
accurate impedance measurements at frequencies up to 100 kHz. EIS
performance is good for low-impedance systems (such as low-ESR
electrical double-layer capacitors).
A unique DSP (Digital Signal Processing) data-acquisition mode allows
the EIS Box to reject noise, from the instrument itself, from the
electrochemical cell, and from the lab environment. In many cases
where other instruments require a cell in a Faraday shield to make quiet
measurements, the EIS Box can be used with the cell exposed on a bench
top.
The EIS Box, like all our instruments, requires a computer for its use. The
EIS Box connects to this computer through an Ethernet or USB
connection (see photograph below of rear panel).
The EIS Box was developed to increase the throughput of your
impedance testing program. Under the control of an external computer,
the EIS Box connects one cell at a time, which makes an electrochemical
measurement on that cell.
The EIS Box has been integrated into all Gamry Instruments'
electrochemical impedance spectroscopy applications that run under the
Gamry Framework. It allows many of the EIS measurement applications
to increase their throughput by testing multiple cells in a single test run.
The Gamry Instruments Electrochemical Toolkit allows you to control the
EIS Box using a library of software routines. You can find examples of
such routines after you install the Electrochemical Toolkit software.
Introduction to the EIS Box
Typical applications for the EIS Box include:
•
Research in electrochemical storage and conversion, and
•
Battery and electrochemical capacitor evaluation.
General Operation
The EIS Box was developed to increase the throughput of your
electrochemical impedance testing program. It allows one instrument to
drive up to eight electrochemical cells. Under the control of an external
computer, the EIS Box connects one cell at a time to the instrument,
which makes an electrochemical measurement on that cell.
The EIS Box was specially designed for the needs of electrochemists.
Extra features such as sense line and shield-switching—designed
specifically for electrochemists—from other general-purpose switching
devices.
It allows many of the applications to increase their throughput by testing
multiple cells in a single test run.
Operation Overview
Figure 3-1 shows a "typical" electrochemical test system built around an
EIS Box instrument. Only four cells are shown in this figure, although up
to eight cells can be connected.
Figure 3-1 A Typical Electrochemical Test System Using the EIS Box
The system computer is a critical component of the system. It controls
the EIS Box by sending it simple commands through an ethernet or USB
connection.
The most important function of these commands is to select which cell is
active (connected to the EIS Box). You can think of an EIS Box as a