Airflow Uno hab Kit di installazione - Pagina 4

Sfoglia online o scarica il pdf Kit di installazione per Sistema di riscaldamento Airflow Uno hab. Airflow Uno hab 16. Cavity wall decentralised mechanical ventilation with heat recovery unit
Anche per Airflow Uno hab: Manuale di installazione e istruzioni per l'uso (16 pagine), Istruzioni (2 pagine), Manuale di manutenzione (2 pagine)

Stampa la pagina
CHAPTER 1
SAFETY
m
DANGER
m
WARNING
m
CAUTION
m
DANGER
m
CAUTION
© Airflow - we reserve the right to make changes without prior notice
1.0

Important information

In order to ensure complete and effective operation and for your own safety, all of the following instructions
should be carefully read and followed.
This document should be kept safe in an accessible location to ensure safe operation of the product. All product-
related safety regulations must be followed.

1.1 Warning instructions

The accompanying symbols are safety-relevant prominent warning
symbols. All safety regulations and/or symbols in this document must
be absolutely adhered to, so that any risks of injury and dangerous
situations are avoided!

1.2 Safety instructions

For any work carried out on the product, should be completed by a suitably
competent person and comply to the relevant local/international standard
and adhere to these installation and operation instructions.
The following must be read before any cleaning, electrical, installation,
•
servicing and maintenance work is carried out:
– Isolate the device from the mains power supply and secure against any
power supply. Do not attempt to install when powered.
– Ensure that the rotating parts have come to a standstill.
– Once the rotating parts come to a standstill position, wait for at least 3
minutes, as dangerous voltages may be present due to internal capacitors
even after disconnection from the mains.
All product-related safety regulations must be followed.
•
If applicable, further country-specific regulations must also be followed.
•
Protection against any physical contact must be ensured and comply to
DIN EN 13857 in the installed condition (see section 2.9).
Contact with rotating parts must be avoided.
Air inlets and outlets must be open and not obstructed in any way.
•
•
When using a vented fire place (chimney) in a ventilated room, there must
be sufficient supply air for all operating conditions. See 2.8
Fireplaces.
The current locally applicable regulations and laws must be followed.
1.3

Application

Normal use:
Unohab units are designed for external wall installation. The air outlet is on the external side of the wall via an
external grille. The air inlet is located on the internal side of the wall with an integrated coarse air filter and sound
insulation.
In order to ensure balanced ventilation, at least 2 units are required for one functional system, which operate in
alternating directions (switch between supply air and extract air every 60 sec) in the selected operating mode.
Depending on the overall air flow rate requirements of the dwelling, more than 2 units can be installed with the fan
speeds / air flow rates adjusted by means of the Unohab controller.
When operating under various conditions, such as high levels of humidity, long standstill periods, electrical
overloads, etc. please contact Airflow technical services.
Use of this product outside of its intended operation, as outlined in this instruction manual, is prohibited.
Unohab Cavity Wall Installation Kit
4
Installation and Operating Instructions