Makita 6228DWE Manuale di istruzioni - Pagina 12

Sfoglia online o scarica il pdf Manuale di istruzioni per Trapano Makita 6228DWE. Makita 6228DWE 19. 9.6 v i2 v 14.4 v
Anche per Makita 6228DWE: Manuale di istruzioni (19 pagine), Manuale di istruzioni (19 pagine), Manuale di istruzioni (19 pagine)

Stampa la pagina

OPERATION

Nominal diameter of

m d screw (mml

Screwdriving operation

Place the point of the driver bit in the

screw head and apply pressure to the tool.

Start the tool slowly and then increase the

speed gradually. Release the trigger as

soon as the clutch cuts in.

Recommended size of

pilot hole (mml

NOTE:

*Make sure that the driver bit is inserted straight in the screw head, or the screw and/or

bit may be damaged.

3.1 (l/e")

3.5

(W'I

3.8

15/32")

4.5 (11M'I

4.8

(3/16")

5.1 (13,"')

5.5 (7/32"l

5.8 (7/32"1

6.1 (15M"I

*When driving wood screws, predrill pilot

holes to make driving easier and to pre-

vent splitting of the workpiece. See the

chart.

2.0-

2.2

(5/64"

3/32")

2.3

2.5 13/32''

3/32'?

2.5- 2.8

13/32"

7/61',)

2.9

3.2 (7B-I"

1W'I

3.1

3.4 (1W'

9/64")

3.3

3.6 (1W'

9/64")

3.7

3.9 (9/4"

5/32"]

4.0-4.2 W32"

11/64")

4.2-4.4(11/64"- 11/61")

*If the tool is operated continuously until the battery cartridge has discharged, allow the

tool to rest for 15 minutes before proceeding with a fresh battery.

Drilling operation

First, turn the adjusting ring so that the pointer on the tool body points to the

marking.

Then proceed as follows.

*Drilling in wood

When drilling in wood, best results are obtained with wood drills equipped with a guide

screw. The guide screw makes drilling easier by pulling the bit into the workpiece.

prevent the bit from slipping when starting

hole, make an indentation with

center-

punch and hammer at the point to be drilled. Place the point of the bit in the indentation

and start drilling.

Use a cutting lubricant when drilling metals. The exceptions are iron and brass which

should be drilled dry.

*Drilling in metal