Alinco DJ-196 Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Radio bidirezionale Alinco DJ-196. Alinco DJ-196 18. Vhf/uhf fm transceiver
Anche per Alinco DJ-196: Manuale di istruzioni (20 pagine)

Alinco DJ-196 Manuale di istruzioni
5 Operation 1 (Basics)
5-1 Adjusting the Volume
. [VOL」 appears on LCD when VOL key is pressed, volume level is displayed.
The initial value is 00 (minimum). The volume can be increased or decreased by
rotating the dial. The maximum value is 20.
 There are 21 steps from 00-20 in volume adjustment. The setting value can be
kept even while the power is off.
. When the volume point data is (00), the voice can not be heard.
Press any key (except for FUNC, MONI key) to complete the setting. The LCD
returns to the ordinal mode.
When no operation is continued for 5 seconds, the setting is completed automatically.
Then the LCD will return to the ordinal mode.
【Operation】The volume increases as the setting value increases.
5-2 Adjusting the Squelch
Press the SQL key, and "SQL" icon appears on the LCD. Then the squelch level is displayed.
The initial setting value is 00 (minimum). The squelch level can be increased or decreased by
rotating the dial. This value can be kept while the power is turned OFF.
. There are 21 steps from 00-20 in the squelch level.
. Press any key (except for FUNC and MONI keys) to complete the setting. Then the LCD
returns to the ordinal mode.
. When no operation is continued for 5 seconds, the setting is completed automatically. Then the
LCD will return to the ordinal mode.
【Operation】The squelch will be opened with the strong signal when the high value is set.
5-3 Receiving
1. Turn the power SW ON.
2. Press the VOL key to increase the volume. Rotate the dial to set to the proper
volume.
3. Press and hold the SQL key, and rotate the dial until the noise disappears.
4. Select the desired frequency. [BUSY] appears on the LCD as soon as the signal is
received in the desired frequency. Then receiving voice is heard. At the same time green RX
indicator lights up.
5-4 Transmitting
1. Select the desired frequency.
2. Press the PTT key, and the red TX indicator lights up to show the unit starts transmitting.
While pressing PTT key, speak to the internal microphone on the front of the unit
with your normal voice.
3. The transmission will be completed when the PTT key is released, then the unit
returns to the receiving mode.
Note: Press and hold the PTT key, then press MONI key to transmit the tone burst.
Note: If the PTT key is pressed outside the transmission frequency range, [OFF] will
appear on the LCD and you can not transmit.
5-5 Frequency Selection
1. Each time the V/M key is pressed, the mode is switched between VFO mode and memory mode.
2. VFO mode is selected by V/M key