AEG FBB83706PM Manuale d'uso - Pagina 22
Sfoglia online o scarica il pdf Manuale d'uso per Lavatrice AEG FBB83706PM. AEG FBB83706PM 28.
Anche per AEG FBB83706PM: Istruzioni per l'installazione (4 pagine)
Stampa la pagina
22
www.aeg.com
• Use the automatic cleaning
programme for optimal cleaning
results.
• Using short-duration programmes
regularly can cause grease and
limescale buildup inside the
appliance. Run long-duration
programmes at least twice a month to
prevent the buildup.
11.5 Removal of foreign
objects
Check the filters and the sump after each
use of the dishwasher. Foreign objects
12. TROUBLESHOOTING
WARNING!
Improper repair of the
appliance may pose a
danger to the safety of the
user. Any repairs must be
performed by qualified
personnel.
The majority of problems that may
occur can be solved without the need
Problem and alarm code
You cannot activate the ap‐
pliance.
The programme does not
start.
The appliance does not fill
with water.
The display shows i10 or
i11.
(e.g. pieces of glass, plastic, bones or
toothpicks, etc) decrease the cleaning
performance and can cause damage to
the drain pump.
1. Disassemble the filters system as
instructed in this chapter.
2. Remove any foreign objects
manually.
3. Reassemble the filters as instructed
in this chapter.
to contact an Authorised Service
Centre.
Refer to the below table for information
on possible problems.
With some problems, the display shows
an alarm code.
Possible cause and solution
•
Make sure that the mains plug is connected to the mains
socket.
•
Make sure that there is no damaged fuse in the fuse
box.
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the
end of the countdown.
•
The appliance recharges the resin inside the water soft‐
ener. The duration of the procedure is approximately 5
minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not
too low. For this information, contact your local water
authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
CAUTION!
If unable to remove the
foreign objects, contact an
Authorised Service Centre.