A-Neuvideo EP-132 Manuale di istruzioni - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per Convertitore multimediale A-Neuvideo EP-132. A-Neuvideo EP-132 20. Serial to ethernet converter
Stampa la paginaA
NEUVIDEO
RIGHT SIDE
LED INDICATORS
Terminator & Reset button
Reset Button
Press the button then turn on the power and wait for 3
seconds. Converter will reset to factory default.
Terminator
There terminator resistor is built-in. If switch 1 & 2 are
set in "ON" position, 120 Ohm resistor will be connected
between the signals.
Converter Description
RS-232
RS-422 / 485
SyS "Red lED":
Power indicated (When power on, LED will flash each time in
one second.)
Rx "green lED":
Network signal receiving indicated (When receive any signal
form network LED will flash.)
Tx "Red lED":
Network signal transforming indicated (When transmit any signal
to network LED will flash.)
lAN "lED":
On-line indicated (When converter link to LAN then the LED will keep
on.) 100M- Green LED/10M- Red LED
TERMINATOR
RESET BUTTON
5
Serial Port of RS-232/RS-422/RS-485
Connect serial data cable between the converter and
serial device. Follow the setup procedure to configure
the parameters of the converter. (See the following
chapters)