AEG TR834E94E Manuale d'uso - Pagina 19
Sfoglia online o scarica il pdf Manuale d'uso per Asciugatrice AEG TR834E94E. AEG TR834E94E 32.
Stampa la pagina
activated, the acoustic signal sounds
intermittently for 1 minute.
If you do not turn off the appliance, the
anti-crease phase starts (not active with
all programmes). Flashing
signals the execution of the anti-crease
phase. Laundry can be removed during
this phase.
To remove the laundry:
1. Push the On/Off button for 2 seconds to
turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
Adjustment of default dryness
See chapter
level
• Room temperature is too low or too high.
Optimal room temperature is between
18°-25°C.
9. HINTS AND TIPS
9.1 Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which are
specified in the programmes chapter.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• The water from the water container can be
used to iron the clothes. You must first
filter the water to eliminate remaining
textile fibres (simple coffee filter is
suitable).
• Always keep the airflow slots at the bottom
of the appliance clear.
• Make sure there is good airflow where the
appliance is to be installed.
9.2 Adjustment of default dryness
level
To change the default dryness level:
1. Turn the appliance on.
8.12 Drum light on
symbol
Touch and hold down Silent button by
around 3 seconds.
The light inside the drum is on.
8.13 Possible causes of
unsatisfactory drying results:
• The filter is clogged. Clogged filter makes
• The airflow slots are clogged.
• The humidity sensor is dirty.
• The drum is dirty.
• Inadequate default dryness level settings.
• Room temperature is too low or too high.
2. Select 1 of the available programmes.
3. Touch and hold down the Time Dry and +
One of the symbols appears on the display:
4. Touch the Start/Pause button repeatedly
Dryness level
Maximum dry‐
ness
Extra dryness
Standard dry‐
ness
5. To memorise the setting touch and hold
drying inefficient.
Adjustment of default dryness
See chapter
level
Optimal room temperature is between
18°-25°C.
Anti Crease buttons at the same time.
- Maximum dryness
- Extra dryness
- Standard dryness
until you reach the desired dryness level.
Display symbol
down the Time Dry and + Anti Crease
ENGLISH
19