Kohler 18RESL Manuale operativo - Pagina 24

Sfoglia online o scarica il pdf Manuale operativo per Generatore portatile Kohler 18RESL. Kohler 18RESL 48. Residential/commercial generator sets
Anche per Kohler 18RESL: Manuale di installazione (40 pagine), Funzionamento (48 pagine)

Stampa la pagina

3. Fill with oil.

a. Remove the oil fill cap and fill the engine to the F

mark on the dipstick. The engine oil capacity is

1.9 L (2.0 qt.). See Section 3.3.3, Engine Oil

Recommendation, for oil selection.

b. Reinstall the dipstick and the oil fill cap.

c. Check that the generator set master switch is in

the OFF position.

d. Reconnect the generator set engine starting

battery, negative (--) lead last.

e. Reconnect the power to the battery charger.

f. Start and run the generator set for a minute to

allow the oil pressure to reach the operating

range.

g. Stop the generator set, wait 1 minute, and then

recheck the oil level. Add oil to bring the level

up to the F mark on the dipstick.

4. Check for leaks.

a. Check for oil leaks.

b. Fix leaks and recheck the oil level.

c. Reinstall the housing side panel.

3.3.5

Oil Cooler

Inspect and clean the oil cooler at the intervals shown in

the Service Schedule. The oil cooler must be kept free

of debris.

See Figure 3-2 for the oil cooler location. Clean the

outside of the oil cooler with a brush or compressed air.

If it is necessary to clean the back of the oil cooler,

remove the two screws holding the oil cooler unit to the

blower hosing. Tilt the cooler and clean with a brush or

compressed air as shown in Figure 3-3. After cleaning,

reinstall the oil cooler and secure with the mounting

screws.

Section 3 Scheduled Maintenance, 12 kW Models

1. Oil filter

2. Oil cooler

Figure 3-2 Oil Cooler Location

Figure 3-3 Cleaning Oil Cooler

24 590 01--A

TP-6517 1/11