A. Mallios Pamal WP Manuale di avvio rapido

Sfoglia online o scarica il pdf Manuale di avvio rapido per Lanterna A. Mallios Pamal WP. A. Mallios Pamal WP 2.

TECHNICAL CHARACTERISTICS
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERIES Ni-Cd
(
)
BATTERY PROTECTION
INDICATIONS CONTROLS
-
CHARGING TIME
MINIMUM AUTONOMOUS DURATION
ILLUMINATION SOURCE
EMERGENCY ILLUMINATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
GENERAL
These luminaires are used in places where
emergency luminaires are needed.
Each luminaire must be permanently connected
to mains power supply In normal operation the
led strip lights and the battery is charging. In
case of a mains power supply failure the
luminaire will light the led strip automatically in
emergency mode.
supply is restored the device turns to normal
operation.
ΑΤΤΕΝΤΙΟΝ!!!
1. Operations for installation, maintainance or
testing must be done by authorized personel
only
.
2.
The device must be connected to the mains
power supply thru a fuse dependent by the total
amount of the line's power load
3.
It is sugested to check every month the
indication LED for battery charging, and by
pushing the TEST button (see the paragraph 8
on page 2), to check the emergency cirquit. The
lamp should light as long as the TEST button is
pressed
. In the opposite condition contact the
installer.
4.
It is sugested to check every 6 months the
minimum autononous duration by disconnecting
the mains power supply Count the time that the
led strip lights and in case of less time than the
minimum autonomous duration the battery must
be replaced. If the measured time is
4.8V/1.5Ah
.
When the
mains
power
.
.
Pamal WP
220-240V AC/50-60Hz
4 VA
From overcharge and full discharge
Charge indication LED TEST button
6 power LED's
EN 60598-1, EN 60598-2-22
Bayblent F 3010 transparent polycarbonate
R
355 x 145 x 73 mm
3 years
(1
considerably less than the minimum autonomous
duration
contact the installer.
led strip replacement, these must be replaced by
parts of the same type
5.
In case of inactive use for a period greater
than 2 months, disconnect the battery by pulling
out the battery's connector.
6. I s not allowed to discard batteries in to
t i
common trash bins, they must be discarded
only
in battery recycling points. Do not
incinerate.
INSTALLATION
To install the luminaire follow the installation
instructions in page 2.
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
0: Non Maintained
A: Including test device
*90: 90min duration
180: 180min duration
5 VA
4.8V/3Ah
,
24h
180min
370lm
IP 65
o
0 to 40 C
Up to 95%
,
1020gr.
year for the battery
)
In case of battery or
.
6 VA
4.8V/4Ah(Ni-MH)