Aqua EZ APC493 Manuale di installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di installazione per Aspiratore per piscina Aqua EZ APC493. Aqua EZ APC493 6.

Step 1

Step 1: Stretch the Skirt #2, over the Foot #1, by starting at the corner of the Foot #1. Rotate the skirt in a circular

direction while stretching the Skirt #2 over the Foot #1. Once you have completed a full circle the Skirt #2 should

now be resting freely in the skirt channel of the Foot #1.

Step 2

Step 2: Snap the De ector Wheel #4, onto the Hose Section #5, with the curved ns of the de ector facing up.

The De ector needs to be 4 inches from the bottom of the female end of the Hose #5.

Step 3: Insert the assembled Body #3, into the female end of the Hose Section #5,

Step 4: Clip one Hose Weight #9, onto the Hose Section #5 about 1 foot above the De ector Wheel #4. The position

of this weight will be changed later to adjust the EZ-Vac's vacuuming angle.

Step 3

For corner or end installations

If your skimmer or wall vacuum tting is located at the corner or end of your pool,

use enough hose sections to reach the farthest point in the pool, plus one (1) section.

For center installations

If your skimmer or wall vacuum tting is located at the center of your pool, use

enough hose section to reach the farthest point in the pool, plus two (2) sections.

Hose Assembly

After determining the amount of Hose Sections #5 needed, Connect all sections.

Make sure that this is done with the hose fully submerged under the water.

Angle the hose so that all air is removed from each hose section before you connect

them together.

Step 4