A.J.Antunes McDONALD'S MEC-600 Manuale - Pagina 3
Sfoglia online o scarica il pdf Manuale per Fornello per uova A.J.Antunes McDONALD'S MEC-600. A.J.Antunes McDONALD'S MEC-600 14.
Stampa la pagina
Throughout this manual, you will find the following safety words and symbols that signify important safety issues with
regards to operating or maintaining the equipment.
WARNING
GENERAL WARNING. Indicates informa-
tion important to the proper operation of
the equipment. Failure to observe may
result in damage to the equipment and/or
severe bodily injury or death.
CAUTION
GENERAL CAUTION. Indicates informa-
tion important to the proper operation of
the equipment. Failure to observe may
result in damage to the equipment.
In addition to the warnings and cautions in this manual,
use the following guidelines for safe operation of the
unit.
• Read all instructions before using equipment.
• Install or locate the equipment only for its intend-
ed use as described in this manual.
• Do not use corrosive chemicals in this equipment.
• Do not operate this equipment if it has a dam-
aged cord or plug; if it is not working properly, or
if it has been damaged or dropped.
• This equipment should be serviced by qualified
personnel only. Contact the nearest Roundup
authorized service facility for adjustment or repair.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
P/N 1010877 Rev. E 01/05
McDonald's
IMPORTANT SAFETY INFORMATION
MANUAL EGG COOKER/STEAMER
WARNING
ELECTRICAL WARNING. Indicates infor-
mation relating to possible shock hazard.
Failure to observe may result in damage
to the equipment and/or severe bodily
injury or death.
WARNING
HOT SURFACE WARNING. Indicates
information important to the handling of
equipment and parts. Failure to observe
caution could result in personal injury.
The following warnings and cautions appear
throughout this manual and should be carefully
observed.
• Turn the unit off, disconnect the power source
and allow unit to cool down before performing
any service or maintenance on the unit.
• The procedures in this chapter may include
the use of chemical products. These chemi-
cal products will be highlighted with bold
face letters followed by the abbreviated HCS
(Hazard Communication Standard). See your
Hazard Communication Standard manual for
the appropriate Material Safety Data Sheets
(MSDS).
• The equipment should be grounded accord-
ing to local electrical codes to prevent the
possibility of electrical shock. This requires
a grounded receptacle with separate electri-
cal lines to be protected by fuse(s) or circuit
breaker(s) of the proper rating.
• All electrical service connections must be in
accordance with local and/or other applicable
electrical codes.
3