Abacus Electric Evolve Sonix Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di sicurezza Abacus Electric Evolve Sonix. Abacus Electric Evolve Sonix 10. Wireless gsm alarm

Stampa la pagina

B) Adding the sensors in the inner protective zone (the sensors in this zone work when the mode Full

activation is active; if the alarm is in the mode Partial activation the inner sensors don´t work):

When you activate the GSM module the LED warning light on the device will temporarily go red. Press the

button "reset" for one second. The LED warning light will change the colour to orange for 20 seconds now.

That indicates that the alarm is in the mode of learning the codes of the inner protective zone. In this

time you can switch on other sensors of the inner protective zone and the blink of the red warning light

will confirm you that they were successfully paired to the main drive. The coding mode will end

automatically after 20 seconds and the alarm will switch over to the working mode where the LED warning

light on it will change at first to orange (searching the GSM nets) and then to green.

Note: If the four wireless sensors for the zones 1 – 4 are connected to the main drive then the newly added

sensor will be stated in the alarm as the fifth zone.

How to cancel the lost sensors?

In case that the paired sensors are lost you can encode them from the alarm main drive so they would not

affect the alarm functioning. Press and hold the pressed button "reset" and on top of that press the

button of power supply (the alarm switch on). The beep will be heard and the LED warning light will start

blinking as the confirmation that the reset of the device was successful. All the registered sensors were

deleted from the alarm main drive. Now recode again using the procedure described above only those

sensors that are available. The system reset will not affect the content of the preset SMS messages.

The basic consignment contains:

1 pc - Alarm main (control) drive

1 pc - Wireless PIR detector

1 pc - Wireless door sensor (opening sensor)

4 pcs - Remote controls

The following sensors can be arbitrarily bought in addition (the optional sensors/detectors are packed

individually, you can buy them in addition as actually needed):

Wireless magnetic sensor for the window/door, wireless PIR sensor, remote control, wireless smoke

detector, wireless outdoor siren, wireless glass breaking/vibration detector, wireless keypad for the alarm

activation/deactivation, wireless mini siren, wireless ceiling PIR sensor (movement sensor), wireless PIR

sensor (movement sensor) immune against the small animals movement, wireless SOS key - more

information at

www.evolve-europe.com

The chosen technical parameters

- Static current: 50mA

- Power supply: 9V-12V DC

- Operation temperature: -20°C ~ +85°C

- GSM 900/1800 MHz

- Receiving code: ASK

- Frequency: 315/433 MHz

- Wireless coverage: 100 m

- Wireless detectors: 16

- Wire detectors: 3

1 pc - Antenna

1 pc - Wire mini siren 110dB/0,3m

1 pc - Power supply adaptor

1 pc - Loudspeaker

Wireless detector for opening (door/window

contact)

- Power supply: DC12V (inner 12V battery)

- Static current: ≤20 mA

- Transmission current: ≤15 mA

- Transmission frequency: 315/433 ± 0,5 MHz

- Wireless coverage: in open space 80 m

- Inner distance: 15 mm

- Operation conditions: temperature –10°C ~ +

40°C/humidity ≤ 90% rh