Dell PowerEdge R520 Manuale - Pagina 10

Sfoglia online o scarica il pdf Manuale per Immagazzinamento Dell PowerEdge R520. Dell PowerEdge R520 11. 2-socket, 2u rack server
Anche per Dell PowerEdge R520: Manuale di installazione (8 pagine), Manuale introduttivo (9 pagine), Manuale del portafoglio (27 pagine), Manuale tecnico (50 pagine)

Cable Routing Procedures for the Dell PowerEdge R520 System

Section 3: Cabling a PowerEdge R520 system on sliding rails

without a CMA

NOTE: The CMA for the Dell PowerEdge R520 system is optional. Without the CMA installed, the system

must be powered down and all cables disconnected before it can be extended out of the rack.

1. Connect all applicable cables to the rear of the system and verify that all connections are secure.

2. Using the hook-and-loop straps supplied with the rail kit, bundle the cables and secure them to

either the left or right outer CMA attachment bracket as described in the Rack Installation

Instructions. See Figure 10 for an example of data cables secured to the left outer CMA bracket and

power cables secured to the right outer CMA bracket (as viewed from the rear of the system).

Figure 10.

If you are installing the system into a shallow rack (less than 1 meter deep) and you will not be

installing a CMA, the outer CMA brackets may be removed from the sliding rails if necessary in order to

allow the rails to fit properly into the rack. Remove the brackets by using a #2 Phillips screwdriver to

remove the screws that secure the brackets to the rails as shown in Figure 11. Use the hook-and-loop

straps supplied with the rail kit to secure the cables to the rack frame if desired.

Cable routing on sliding rails without a CMA