Aquasana AQ-SFRO Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di filtrazione dell'acqua Aquasana AQ-SFRO. Aquasana AQ-SFRO 13. Under sink water filter smartflow reverse osmosis

Stampa la pagina

INSTALLATION STEPS

Install Drain Saddle

A. Identify drain outlet location on drainpipe to install drain clamp. Do not

install drain clamp on the same drainpipe as garbage disposal. Mount

drain clamp as low as possible on the vertical or

horizontal drainpipe tailpiece.

B. Using the drain connector hole as a template, drill a 7/16" hole into the

drainpipe. Only drill through one side of the drainpipe.

C. Take the connection half of the

drain clamp and attach the foam

gasket. Do so by removing the

center hole and protective cover

from the back of the foam gasket.

Align the foam gasket hole with

the hole on the inside of the drain

clamp. The adhesive side of the

foam gasket should be facing the

inside of the drain clamp. Press

firmly to attach.

D. Insert nuts into the other half of

the drain clamp. Place both halves

together around the drainpipe,

aligning with the hole you drilled.

Use drill bit to help align.

E. Tighten nuts and screws to secure

the drain clamp halves around the

drainpipe. Tighten with screwdriver.

Do not over tighten.

Install Inlet Tee Valve and Tubing

NOTE: Ensure water valve is turned off before continuing.

A. Place a pan or bucket under cold water line to catch any excess water.

With an adjustable wrench, disconnect COLD water line from the supply

line at shut-off valve.

B. Attach threaded ends of inlet tee valve to the cold water line of the

shut-off valve. Tighten with wrench. Do not over tighten.

C. Reattach the cold water line to the top of the tee valve.

D. Push white tubing into the open quick connect valve. Ensure inlet tee

valve is in the open position.

Install System Manifold and

Remineralizer Bracket

A. Place system manifold under the sink

in a place that will be easy to access for

scheduled filter changes. Do not install

filter cartridges at this time.

B. Using your screw driver and included

screw, install the bracket on your cabinet

wall near the system manifold. Insert

remineralizer cartridge with sticker

text upward.

NOTE: Placement of bracket must be close to system manifold to ensure tube

length needed for connection is sufficient.

INSTALLATION STEPS

CLOSED

OPEN