aquatherm AT600 Manuale di installazione - Pagina 14

Sfoglia online o scarica il pdf Manuale di installazione per Pompa di calore aquatherm AT600. aquatherm AT600 16. Swimming pool & spa heat pumps
Anche per aquatherm AT600: Manuale operativo del proprietario (12 pagine), Manuale operativo del proprietario (12 pagine)

"Prologic" Analog Control Panel Information

TEMPERATURE CONTROLS: The top Thermostat controls the pool temperature. The

bottom Thermostat controls the spa temperature. If you do not have a spa you can use

the two thermostats as a high and low temperature preset.

THERMOSTAT/OFF SWITCH- POOL/OFF/SPA: The Thermostat/Off Switch determines

which thermostat is active, up for pool, down for spa. You can disable the heater by

placing the selector switch in the center "OFF" position.

GREEN POWER LIGHT: This light indicates that the heater has control power. WARN-

ING: This is not a line power indicator and caution should be used since more than one

power disconnection may be required to isolate the heater electrically. WARNING: If

the optional Time Clock Override is installed, you must shut off the water pumps main

power disconnect as well.

BLUE HEATING LIGHT: This light indicates that the unit is heating and the compressor

is running. The compressor starts after a 5 to 7 minute time delay. NOTE: The water

pump must be running at the same time in order for the heater to run.

AMBER NO WATER FLOW LIGHT: This light indicates there is no water flow through the

heater. The heater is designed to shut off whenever the water pump is not pumping

water through the heater. If this light is on while the water pump is running, the water

pump may not be supplying enough flow for the heater to operate properly. During

normal operation the heater turns off and on with the water pump, (as long as the

thermostat is calling for heat).

RED FAULT LIGHT: This light indicates that the internal safety control system has dis-

abled the heater. If either the high or low refrigerant pressure switch has tripped this

light will come on. NOTE: During cold weather where the air temperature drops

below approximately 45 to 50 degrees (depending on humidity), the low refrig-

erant pressure switch (or defrost control), is designed to disable the heater. In

this "defrost mode" the fan and compressor will shut off. When the defrost

switch resets for whatever reason the fan will restart, then after a 5 to 7 minute

time delay the compressor will attempt to restart. In some case where the air

temperature are in a borderline range, the heater my cycle on & off in an at-

tempt to reset. The heater should be shut off when the air temperature is ex-

pected to drop below the operational range for an extended period. The high

refrigerant pressure switch is designed to shut the compressor and fan off if a heat

buildup occurs for what ever reason. Typically the high refrigerant pressure switch will

trip if the water flow through the heater is restricted. It may also trip if the air flow is

restricted through the heater.

NOTES: The heater will never run without water running through it from the filter pump.

The heater will not heat faster if you turn the thermostat knob up higher.

Page 14