Aquatic Access IGAT-180 AD Manuale di installazione / Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di installazione / Manuale di istruzioni per Sistemi di sollevamento Aquatic Access IGAT-180 AD. Aquatic Access IGAT-180 AD 16. Pool lift
Anche per Aquatic Access IGAT-180 AD: Manuale di installazione / Manuale di istruzioni (18 pagine)

Stampa la pagina

DISASSEMBLY OF LIFT AND REPLACEMENT OF PISTON SEAL

1. Remove seat assembly from lift and disconnect water supply. Drain water from Lift.

2. Remove lift from socket.

3. Remove four bolts at top of lift.

4. Pull the piston rod assembly completely

out of cylinder. Be careful not to damage

seal.

5. Remove O-ring and then seal from

bottom of piston. Clean seal and inspect

for signs of cuts, abrasions or tears.

Replace seal if damaged. If original seal is

good reinstall on piston and then replace

O-ring. Make sure O-Ring is seated firmly

in groove.

6. Inspect cylinder for signs of dirt or debris. Formula 409® can be used to clean the inside of

the cylinder and seal. Wrap a soft bath towel around a broom handle and push it through the unit,

taking care not to scratch the inside of the cylinder wall. Rinse out the cylinder with clean water.

It is easier to seat the seal when the inside surface of the cylinder is damp with either Formula

409® or water. Never use any oil or petroleum-based product inside the cylinder, as it will

damage the piston and seal.

7. Carefully slide piston rod assembly back into cylinder. Take care not to damage seal while

replacing piston rod assembly into cylinder.

8. Push piston rod assembly in until piston rests on the bottom of the lift.

9. Align holes in top cylinder bushing with holes at top of main cylinder. Install bolts and attach

pull-pin, but do not tighten bolts completely yet. (See illustration)

10. Install lift into socket. Connect water supply. Purge air as normal.

11. When lift reaches top position tighten four bolts securely. Do not over tighten bolts to avoid

stripping the threads in the plastic.

12. Attach seat assembly.